diff options
| author | Fan Wu <fanwu01@zju.edu.cn> | 2026-03-09 13:24:09 +0000 |
|---|---|---|
| committer | Greg Kroah-Hartman <gregkh@linuxfoundation.org> | 2026-03-19 16:08:40 +0100 |
| commit | 8efd5dcd31e22a9308b16b107a052fcd568c0a99 (patch) | |
| tree | 84a900405c69caf47c76e79e42f7c451f4842671 /drivers | |
| parent | b70c4e5e711931cdd56e6e905737b72f1e649189 (diff) | |
net: ethernet: arc: emac: quiesce interrupts before requesting IRQ
commit 2503d08f8a2de618e5c3a8183b250ff4a2e2d52c upstream.
Normal RX/TX interrupts are enabled later, in arc_emac_open(), so probe
should not see interrupt delivery in the usual case. However, hardware may
still present stale or latched interrupt status left by firmware or the
bootloader.
If probe later unwinds after devm_request_irq() has installed the handler,
such a stale interrupt can still reach arc_emac_intr() during teardown and
race with release of the associated net_device.
Avoid that window by putting the device into a known quiescent state before
requesting the IRQ: disable all EMAC interrupt sources and clear any
pending EMAC interrupt status bits. This keeps the change hardware-focused
and minimal, while preventing spurious IRQ delivery from leftover state.
Fixes: e4f2379db6c6 ("ethernet/arc/arc_emac - Add new driver")
Cc: stable@vger.kernel.org
Signed-off-by: Fan Wu <fanwu01@zju.edu.cn>
Link: https://patch.msgid.link/20260309132409.584966-1-fanwu01@zju.edu.cn
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/net/ethernet/arc/emac_main.c | 11 |
1 files changed, 11 insertions, 0 deletions
diff --git a/drivers/net/ethernet/arc/emac_main.c b/drivers/net/ethernet/arc/emac_main.c index 8283aeee35fb..dde4046cbf01 100644 --- a/drivers/net/ethernet/arc/emac_main.c +++ b/drivers/net/ethernet/arc/emac_main.c @@ -934,6 +934,17 @@ int arc_emac_probe(struct net_device *ndev, int interface) /* Set poll rate so that it polls every 1 ms */ arc_reg_set(priv, R_POLLRATE, clock_frequency / 1000000); + /* + * Put the device into a known quiescent state before requesting + * the IRQ. Clear only EMAC interrupt status bits here; leave the + * MDIO completion bit alone and avoid writing TXPL_MASK, which is + * used to force TX polling rather than acknowledge interrupts. + */ + arc_reg_set(priv, R_ENABLE, 0); + arc_reg_set(priv, R_STATUS, RXINT_MASK | TXINT_MASK | ERR_MASK | + TXCH_MASK | MSER_MASK | RXCR_MASK | + RXFR_MASK | RXFL_MASK); + ndev->irq = irq; dev_info(dev, "IRQ is %d\n", ndev->irq); |