kernel/sound/firewire/fireface/ff.c, branch linux-5.14.y

ALSA: fireface: cease from delayed card registration

2021-06-07T15:14:48Z

The delayed registration of sound card instance brings less benefit than complication of kobject management. This commit ceases from it. Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20210607081250.13397-9-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

ALSA: fireface: add support for RME Fireface UFX (untested)

2020-05-10T10:03:50Z

Fireface UFX was shipped by RME GmbH in 2010, and now discontinued. Although this model has some enhanced feature which Fireface 802 doesn't have (e.g. on-board USB mass storage device class, configuration interface with color display), the functionality relevant to packet communication on IEEE 1394 bus seems to be the same as Fireface 802 (e.g. available number of channels for PCM frame in each sampling transfer frequency). With the assumption, this commit adds support for Fireface UFX. In ALSA fireface driver, these two models are handled as the same one. Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20200510074301.116224-7-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

ALSA: fireface: add support for RME FireFace 802

2020-05-10T10:03:49Z

Fireface 802 was shipped by RME GmbH in 2014. This model supports later protocol for management of isochronous communication and synchronization of sampling transmission frequency. This model consists of below ICs: * TI TSB41AB2 * Xilinx Spartan-6 FPGA XC6SLX16 * TI TMS320 C6747 * SMSC USB3250 Especially, this model just supports IEEE 1394a, against its name which evokes Fireface 800. This commit adds support for Fireface 802 (tested). Userspace applications can transfer PCM frames and MIDI messages via ALSA PCM/Rawmidi interface. I note that 4 channels for ADAt1 and ADAT2 are disabled at higher sampling transfer frequency since isochronous resources reservation fails due to bandwidth limitation of IEEE 1394a. The value read from LATTER_SYNC_STATUS register is slightly different from the one of Fireface UCX. The higher 4 bits and lower 4 bits are swapped within the same byte. Without any assist of userspace application, transmitted MIDI messages from the device are not going to be processed. For detail, please refer to my comment in code of latter protocol. $ python crpp < /sys/bus/firewire/devices/fw1/config_rom ROM header and bus information block ----------------------------------------------------------------- 400 0404ffff bus_info_length 4, crc_length 4, crc 65535 (should be 26805) 404 31333934 bus_name "1394" 408 20008000 irmc 0, cmc 0, isc 1, bmc 0, cyc_clk_acc 0, max_rec 8 (512) 40c 000a3504 company_id 000a35 | 410 38077423 device_id 0438077423 | EUI-64 000a350438077423 root directory ----------------------------------------------------------------- 414 0005ffff directory_length 5, crc 65535 (should be 9514) 418 0c0083c0 node capabilities per IEEE 1394 41c 03000a35 vendor 420 8100000b --> descriptor leaf at 44c 424 8d000007 --> eui-64 leaf at 440 428 d1000001 --> unit directory at 42c unit directory at 42c ----------------------------------------------------------------- 42c 0004ffff directory_length 4, crc 65535 (should be 45134) 430 12000a35 specifier id 434 13000005 version 438 17101800 model 43c 81000008 --> descriptor leaf at 45c eui-64 leaf at 440 ----------------------------------------------------------------- 440 0002ffff leaf_length 2, crc 65535 (should be 60131) 444 000a3504 company_id 000a35 | 448 38077423 device_id 0438077423 | EUI-64 000a350438077423 descriptor leaf at 44c ----------------------------------------------------------------- 44c 0003ffff leaf_length 3, crc 65535 (should be 469) 450 00000000 textual descriptor 454 00000000 minimal ASCII 458 524d4521 "RME!" descriptor leaf at 45c ----------------------------------------------------------------- 45c 0005ffff leaf_length 5, crc 65535 (should be 10561) 460 00000000 textual descriptor 464 00000000 minimal ASCII 468 46697265 "Fire" 46c 66616365 "face" 470 20383032 " 802" Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20200510074301.116224-6-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

ALSA: fireface: code refactoring to decide name of sound card

2020-05-10T10:03:49Z

This commit uses enumeration constants as index of table for the list of name of sound card. Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20200510074301.116224-5-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

ALSA: fireface: code refactoring to add enumeration constants for model identification

2020-05-10T10:03:48Z

In RME fireface series, version field of unit directory in configuration ROM is used to distinguish each model. The value of field is known and it's better to use enumeration constants for code representation. This commit adds enumeration constants for model identification. Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20200510074301.116224-4-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

ALSA: firewire: use KBUILD_MODNAME for struct driver.name instead of string

2020-03-06T14:54:03Z

KBUILD_MODNAME is available to name kernel modules according to its object name. This commit uses the macro instead of string for name field of struct driver since drivers in ALSA firewire stack have the same name of each object name. Signed-off-by: Takashi Sakamoto Link: https://lore.kernel.org/r/20200306135229.11659-1-o-takashi@sakamocchi.jp Signed-off-by: Takashi Iwai

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 345

2019-06-05T15:37:08Z

Based on 1 normalized pattern(s): licensed under the terms of the gnu general public license version 2 extracted by the scancode license scanner the SPDX license identifier GPL-2.0-only has been chosen to replace the boilerplate/reference in 88 file(s). Signed-off-by: Thomas Gleixner Reviewed-by: Alexios Zavras Reviewed-by: Allison Randal Cc: linux-spdx@vger.kernel.org Link: https://lkml.kernel.org/r/20190530000437.521539229@linutronix.de Signed-off-by: Greg Kroah-Hartman

ALSA: fireface: support rx MIDI functionality for Fireface UCX

2019-01-22T16:20:56Z

In latter model of Fireface series, asynchronous transaction includes a prefix byte to indicate the way to decode included MIDI bytes. Upper 4 bits of the prefix byte indicates port number, and the rest 4 bits indicate the way to decode rest of bytes for MIDI messages. Basically the rest bits indicates the number of bytes for MIDI message. However, if the last byte of each MIDi message is included, the rest bits are 0xf. For example: message: f0 00 00 66 14 20 00 00 f7 offset: content (big endian, port 0) '0030: 0x02f00000 '0030: 0x03006614 '0030: 0x03200000 '0030: 0x0ff70000 This commit supports encoding scheme for the above and allows applications to transfer MIDI messages via ALSA rawmidi interface. An unused member (running_status) is reused to keep state of transmission of system exclusive messages. For your information, this is a dump of config rom. $ sudo ./hinawa-config-rom-printer /dev/fw1 { 'bus-info': { 'bmc': False, 'chip_ID': 13225063715, 'cmc': False, 'cyc_clk_acc': 0, 'imc': False, 'isc': True, 'max_rec': 512, 'name': '1394', 'node_vendor_ID': 2613}, 'root-directory': [ [ 'NODE_CAPABILITIES', { 'addressing': {'64': True, 'fix': True, 'prv': False}, 'misc': {'int': False, 'ms': False, 'spt': True}, 'state': { 'atn': False, 'ded': False, 'drq': True, 'elo': False, 'init': False, 'lst': True, 'off': False}, 'testing': {'bas': False, 'ext': False}}], ['VENDOR', 2613], ['DESCRIPTOR', 'RME!'], ['EUI_64', 2873037108442403], [ 'UNIT', [ ['SPECIFIER_ID', 2613], ['VERSION', 4], ['MODEL', 1054720], ['DESCRIPTOR', 'Fireface UCX']]]]} Signed-off-by: Takashi Sakamoto Signed-off-by: Takashi Iwai

ALSA: fireface: add model-dependent parameter for address to receive async transaction for MIDI messages

2019-01-22T16:20:53Z

Between former and latter models, destination address to receive asynchronous transactions for MIDI messages is different. This commit adds model-dependent parameter for the addresses. Signed-off-by: Takashi Sakamoto Signed-off-by: Takashi Iwai

ALSA: fireface: support tx MIDI functionality of Fireface UCX

2019-01-22T16:20:51Z

Fireface UCX transfers asynchronous transactions for MIDI messages. One transaction includes quadlet data therefore it can transfer 3 message bytes as maximum. Base address of the destination is configured by two settings; a register for higher 8 byte of the address, and a bitflag to option register indicates lower 8byte. The register for higher address is 0x'ffff'0000'0034. Unfortunately, firmware v24 includes a bug to ignore registered value for the destination address and transfers to 0x0001xxxxxxxx always. This driver doesn't work well if the bug exists, therefore users should install the latest firmware (v27). The bitflag is a part of value to be written to option register (0x'ffff'0000'0014). lower addr: bitflag (little endian) '0000'0000: 0x00002000 '0000'0080: 0x00004000 '0000'0100: 0x00008000 '0000'0180: 0x00010000 This register includes more options but they are not relevant to packet streaming or MIDI functionality. This driver don't touch it. Furthermore, the transaction is sent to address offset incremented by 4 byte to the offset in previous time. When it reaches base address plus 0x7c, next offset is the base address. Content of the transaction includes a prefix byte. Upper 4 bits of the byte indicates port number, and the rest 4 bits indicate the way to decode rest of bytes for MIDI message. Except for system exclusive messages, the rest bits are the same as status bits of the message without channel bits. For system exclusive messages, the rest bits are encoded according to included message bytes. For example: message: f0 7e 7f 09 01 f7 offset: content (little endian, port 0) '0000: 0x04f07e7f '0004: 0x070901f7 message: f0 00 00 66 14 20 00 00 00 f7 offset: content (little endian, port 1) '0014: 0x14f00000 '0018: 0x14661420 '001c: 0x14000000 '0020: 0x15f70000 message: f0 00 00 66 14 20 00 00 f7 offset: content (little endian, port 0) '0078: 0x04f00000 '007c: 0x04661420 '0000: 0x070000f7 This commit supports decoding scheme for the above and allows applications to receive MIDI messages via ALSA rawmidi interface. The lower 8 bytes of destination address is fixed to 0x'0000'0000, thus this driver expects userspace applications to configure option register with bitflag 0x00002000 in advance. Signed-off-by: Takashi Sakamoto Signed-off-by: Takashi Iwai