kernel/net/ipv6/seg6.c, branch linux-6.2.y

Merge git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net

2022-09-08T16:38:30Z

drivers/net/ethernet/freescale/fec.h 7d650df99d52 ("net: fec: add pm_qos support on imx6q platform") 40c79ce13b03 ("net: fec: add stop mode support for imx8 platform") Signed-off-by: Paolo Abeni

ipv6: sr: fix out-of-bounds read when setting HMAC data.

2022-09-05T09:33:34Z

The SRv6 layer allows defining HMAC data that can later be used to sign IPv6 Segment Routing Headers. This configuration is realised via netlink through four attributes: SEG6_ATTR_HMACKEYID, SEG6_ATTR_SECRET, SEG6_ATTR_SECRETLEN and SEG6_ATTR_ALGID. Because the SECRETLEN attribute is decoupled from the actual length of the SECRET attribute, it is possible to provide invalid combinations (e.g., secret = "", secretlen = 64). This case is not checked in the code and with an appropriately crafted netlink message, an out-of-bounds read of up to 64 bytes (max secret length) can occur past the skb end pointer and into skb_shared_info: Breakpoint 1, seg6_genl_sethmac (skb=, info=) at net/ipv6/seg6.c:208 208 memcpy(hinfo->secret, secret, slen); (gdb) bt #0 seg6_genl_sethmac (skb=, info=) at net/ipv6/seg6.c:208 #1 0xffffffff81e012e9 in genl_family_rcv_msg_doit (skb=skb@entry=0xffff88800b1f9f00, nlh=nlh@entry=0xffff88800b1b7600, extack=extack@entry=0xffffc90000ba7af0, ops=ops@entry=0xffffc90000ba7a80, hdrlen=4, net=0xffffffff84237580 , family=, family=) at net/netlink/genetlink.c:731 #2 0xffffffff81e01435 in genl_family_rcv_msg (extack=0xffffc90000ba7af0, nlh=0xffff88800b1b7600, skb=0xffff88800b1f9f00, family=0xffffffff82fef6c0 ) at net/netlink/genetlink.c:775 #3 genl_rcv_msg (skb=0xffff88800b1f9f00, nlh=0xffff88800b1b7600, extack=0xffffc90000ba7af0) at net/netlink/genetlink.c:792 #4 0xffffffff81dfffc3 in netlink_rcv_skb (skb=skb@entry=0xffff88800b1f9f00, cb=cb@entry=0xffffffff81e01350 ) at net/netlink/af_netlink.c:2501 #5 0xffffffff81e00919 in genl_rcv (skb=0xffff88800b1f9f00) at net/netlink/genetlink.c:803 #6 0xffffffff81dff6ae in netlink_unicast_kernel (ssk=0xffff888010eec800, skb=0xffff88800b1f9f00, sk=0xffff888004aed000) at net/netlink/af_netlink.c:1319 #7 netlink_unicast (ssk=ssk@entry=0xffff888010eec800, skb=skb@entry=0xffff88800b1f9f00, portid=portid@entry=0, nonblock=) at net/netlink/af_netlink.c:1345 #8 0xffffffff81dff9a4 in netlink_sendmsg (sock=, msg=0xffffc90000ba7e48, len=) at net/netlink/af_netlink.c:1921 ... (gdb) p/x ((struct sk_buff *)0xffff88800b1f9f00)->head + ((struct sk_buff *)0xffff88800b1f9f00)->end $1 = 0xffff88800b1b76c0 (gdb) p/x secret $2 = 0xffff88800b1b76c0 (gdb) p slen $3 = 64 '@' The OOB data can then be read back from userspace by dumping HMAC state. This commit fixes this by ensuring SECRETLEN cannot exceed the actual length of SECRET. Reported-by: Lucas Leong Tested: verified that EINVAL is correctly returned when secretlen > len(secret) Fixes: 4f4853dc1c9c1 ("ipv6: sr: implement API to control SR HMAC structure") Signed-off-by: David Lebrun Signed-off-by: David S. Miller

genetlink: start to validate reserved header bytes

2022-08-29T11:47:15Z

We had historically not checked that genlmsghdr.reserved is 0 on input which prevents us from using those precious bytes in the future. One use case would be to extend the cmd field, which is currently just 8 bits wide and 256 is not a lot of commands for some core families. To make sure that new families do the right thing by default put the onus of opting out of validation on existing families. Signed-off-by: Jakub Kicinski Acked-by: Paul Moore (NetLabel) Signed-off-by: David S. Miller

icmp: ICMPV6: Examine invoking packet for Segment Route Headers.

2022-01-04T12:17:35Z

RFC8754 says: ICMP error packets generated within the SR domain are sent to source nodes within the SR domain. The invoking packet in the ICMP error message may contain an SRH. Since the destination address of a packet with an SRH changes as each segment is processed, it may not be the destination used by the socket or application that generated the invoking packet. For the source of an invoking packet to process the ICMP error message, the ultimate destination address of the IPv6 header may be required. The following logic is used to determine the destination address for use by protocol-error handlers. * Walk all extension headers of the invoking IPv6 packet to the routing extension header preceding the upper-layer header. - If routing header is type 4 Segment Routing Header (SRH) o The SID at Segment List[0] may be used as the destination address of the invoking packet. Mangle the skb so the network header points to the invoking packet inside the ICMP packet. The seg6 helpers can then be used on the skb to find any segment routing headers. If found, mark this fact in the IPv6 control block of the skb, and store the offset into the packet of the SRH. Then restore the skb back to its old state. Signed-off-by: Andrew Lunn Reviewed-by: David Ahern Reviewed-by: Willem de Bruijn Signed-off-by: David S. Miller

seg6: export get_srh() for ICMP handling

2022-01-04T12:17:35Z

An ICMP error message can contain in its message body part of an IPv6 packet which invoked the error. Such a packet might contain a segment router header. Export get_srh() so the ICMP code can make use of it. Since his changes the scope of the function from local to global, add the seg6_ prefix to keep the namespace clean. And move it into seg6.c so it is always available, not just when IPV6_SEG6_LWTUNNEL is enabled. Signed-off-by: Andrew Lunn Reviewed-by: David Ahern Reviewed-by: Willem de Bruijn Signed-off-by: David S. Miller

net:ipv6:Remove unneeded semicolon

2021-11-03T11:18:46Z

Eliminate the following coccinelle check warning: net/ipv6/seg6.c:381:2-3 Reported-by: Zeal Robot Signed-off-by: Zhang Mingyu Signed-off-by: David S. Miller

net: ipv6: fix use after free of struct seg6_pernet_data

2021-10-04T12:40:19Z

sdata->tun_src should be freed before sdata is freed because sdata->tun_src is allocated after sdata allocation. So, kfree(sdata) and kfree(rcu_dereference_raw(sdata->tun_src)) are changed code order. Fixes: f04ed7d277e8 ("net: ipv6: check return value of rhashtable_init") Signed-off-by: MichelleJin Signed-off-by: David S. Miller

net: ipv6: check return value of rhashtable_init

2021-09-28T11:59:24Z

When rhashtable_init() fails, it returns -EINVAL. However, since error return value of rhashtable_init is not checked, it can cause use of uninitialized pointers. So, fix unhandled errors of rhashtable_init. Signed-off-by: MichelleJin Reviewed-by: David Ahern Signed-off-by: David S. Miller

net: Remove redundant assignment to err

2021-04-29T22:34:15Z

Variable 'err' is set to -ENOMEM but this value is never read as it is overwritten with a new value later on, hence the 'If statements' and assignments are redundantand and can be removed. Cleans up the following clang-analyzer warning: net/ipv6/seg6.c:126:4: warning: Value stored to 'err' is never read [clang-analyzer-deadcode.DeadStores] Reported-by: Abaci Robot Signed-off-by: Yang Li Signed-off-by: David S. Miller

seg6: fix seg6_validate_srh() to avoid slab-out-of-bounds

2020-06-04T22:39:32Z

The seg6_validate_srh() is used to validate SRH for three cases: case1: SRH of data-plane SRv6 packets to be processed by the Linux kernel. Case2: SRH of the netlink message received from user-space (iproute2) Case3: SRH injected into packets through setsockopt In case1, the SRH can be encoded in the Reduced way (i.e., first SID is carried in DA only and not represented as SID in the SRH) and the seg6_validate_srh() now handles this case correctly. In case2 and case3, the SRH shouldn’t be encoded in the Reduced way otherwise we lose the first segment (i.e., the first hop). The current implementation of the seg6_validate_srh() allow SRH of case2 and case3 to be encoded in the Reduced way. This leads a slab-out-of-bounds problem. This patch verifies SRH of case1, case2 and case3. Allowing case1 to be reduced while preventing SRH of case2 and case3 from being reduced . Reported-by: syzbot+e8c028b62439eac42073@syzkaller.appspotmail.com Reported-by: YueHaibing Fixes: 0cb7498f234e ("seg6: fix SRH processing to comply with RFC8754") Signed-off-by: Ahmed Abdelsalam Signed-off-by: David S. Miller