kernel/include/net/bluetooth, branch linux-2.6.32.y

Bluetooth: Handle L2CAP case when the remote receiver is busy

2009-08-26T07:12:20Z

Implement all issues related to RemoteBusy in the RECV state table. Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Fix rejected connection not disconnecting ACL link

2009-08-22T22:05:58Z

When using DEFER_SETUP on a RFCOMM socket, a SABM frame triggers authorization which when rejected send a DM response. This is fine according to the RFCOMM spec: the responding implementation may replace the "proper" response on the Multiplexer Control channel with a DM frame, sent on the referenced DLCI to indicate that the DLCI is not open, and that the responder would not grant a request to open it later either. But some stacks doesn't seems to cope with this leaving DLCI 0 open after receiving DM frame. To fix it properly a timer was introduced to rfcomm_session which is used to set a timeout when the last active DLC of a session is unlinked, this will give the remote stack some time to reply with a proper DISC frame on DLCI 0 avoiding both sides sending DISC to each other on stacks that follow the specification and taking care of those who don't by taking down DLCI 0. Signed-off-by: Luiz Augusto von Dentz Signed-off-by: Marcel Holtmann

Bluetooth: Full support for receiving L2CAP SREJ frames

2009-08-22T22:03:43Z

Support for receiving of SREJ frames as specified by the state table. Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add support for L2CAP SREJ exception

2009-08-22T22:01:25Z

When L2CAP loses an I-frame we send a SREJ frame to the transmitter side requesting the lost packet. This patch implement all Recv I-frame events on SREJ_SENT state table except the ones that deal with SendRej (the REJ exception at receiver side is yet not implemented). Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add support for FCS option to L2CAP

2009-08-22T21:59:49Z

Implement CRC16 check for L2CAP packets. FCS is used by Streaming Mode and Enhanced Retransmission Mode and is a extra check for the packet content. Using CRC16 is the default, L2CAP won't use FCS only when both side send a "No FCS" request. Initially based on a patch from Nathan Holstein Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add support for Retransmission and Monitor Timers

2009-08-22T21:56:15Z

L2CAP uses retransmission and monitor timers to inquiry the other side about unacked I-frames. After sending each I-frame we (re)start the retransmission timer. If it expires, we start a monitor timer that send a S-frame with P bit set and wait for S-frame with F bit set. If monitor timer expires, try again, at a maximum of L2CAP_DEFAULT_MAX_TX. Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Initial support for retransmission of packets with REJ frames

2009-08-22T21:55:20Z

When receiving an I-frame with unexpected txSeq, receiver side start the recovery procedure by sending a REJ S-frame to the transmitter side. So the transmitter can re-send the lost I-frame. This patch just adds a basic support for retransmission, it doesn't mean that ERTM now has full support for packet retransmission. Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add support for Segmentation and Reassembly of SDUs

2009-08-22T21:53:58Z

ERTM should use Segmentation and Reassembly to break down a SDU in many PDUs on sending data to the other side. On sending packets we queue all 'segments' until end of segmentation and just the add them to the queue for sending. On receiving we create a new SKB with the SDU reassembled. Initially based on a patch from Nathan Holstein Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add initial support for ERTM packets transfers

2009-08-22T21:53:01Z

This patch adds support for ERTM transfers, without retransmission, with txWindow up to 63 and with acknowledgement of packets received. Now the packets are queued before call l2cap_do_send(), so packets couldn't be sent at the time we call l2cap_sock_sendmsg(). They will be sent in an asynchronous way on later calls of l2cap_ertm_send(). Besides if an error occurs on calling l2cap_do_send() we disconnect the channel. Initially based on a patch from Nathan Holstein Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann

Bluetooth: Add configuration support for ERTM and Streaming mode

2009-08-22T21:50:07Z

Add support to config_req and config_rsp to configure ERTM and Streaming mode. If the remote device specifies ERTM or Streaming mode, then the same mode is proposed. Otherwise ERTM or Basic mode is used. And in case of a state 2 device, the remote device should propose the same mode. If not, then the channel gets disconnected. Signed-off-by: Gustavo F. Padovan Signed-off-by: Marcel Holtmann