kernel/include/linux/spi/libertas_spi.h, branch linux-5.11.y

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 152

2019-05-30T18:26:32Z

Based on 1 normalized pattern(s): this program is free software you can redistribute it and or modify it under the terms of the gnu general public license as published by the free software foundation either version 2 of the license or at your option any later version extracted by the scancode license scanner the SPDX license identifier GPL-2.0-or-later has been chosen to replace the boilerplate/reference in 3029 file(s). Signed-off-by: Thomas Gleixner Reviewed-by: Allison Randal Cc: linux-spdx@vger.kernel.org Link: https://lkml.kernel.org/r/20190527070032.746973796@linutronix.de Signed-off-by: Greg Kroah-Hartman

net/libertas: remove GPIO-CS handling in SPI interface code

2009-06-10T17:27:50Z

This removes the dependency on GPIO framework and lets the SPI host driver handle the chip select. The SPI host driver is required to keep the CS active for the entire message unless cs_change says otherwise. This patch collects the two/three single SPI transfers into a message. Also the delay in read path in case use_dummy_writes are not used is moved into the SPI host driver. Tested-by: Mike Rapoport Tested-by: Andrey Yurovsky Signed-off-by: Sebastian Andrzej Siewior Acked-by: Dan Williams Signed-off-by: John W. Linville

libertas: if_spi: add ability to call board specific setup/teardown methods

2009-02-09T20:03:48Z

In certain cases it is required to perform board specific actions before activating libertas G-SPI interface. These actions may include power up of the chip, GPIOs setup, proper pin-strapping and SPI controller config. This patch adds ability to call board specific setup/teardown methods Signed-off-by: Mike Rapoport Acked-by: Andrey Yurovsky Acked-by: Dan Williams Signed-off-by: John W. Linville

libertas: if_spi, driver for libertas GSPI devices

2009-01-29T21:00:19Z

Add initial support for libertas devices using a GSPI interface. This has been tested with the 8686. GSPI is intended to be used on embedded systems. Board-specific parameters are required (see libertas_spi.h). Thanks to everyone who took a look at the earlier versions of the patch. Signed-off-by: Colin McCabe Signed-off-by: Andrey Yurovsky Acked-by: Dan Williams Signed-off-by: John W. Linville