kernel/include/linux/mtd/nand.h, branch linux-2.6.34.y

mtd: nand: add option to quieten off the no device found messgae

2009-11-30T09:48:31Z

Add NAND_SCAN_SILENT_NODEV to chip->options to the user-worrying messages 'No NAND device found!!!'. This message often worries users (was three exclamation marks really necessary?) and especially in systems such as the Simtec Osiris where there may be optional NAND devices which are not known until probe time. Revised version of the original NAND_PROBE_SPECULATIVE patch after comments by Artem Bityutskiy about adding a whole new call. Signed-off-by: Ben Dooks Signed-off-by: Simtec Linux Team Signed-off-by: Artem Bityutskiy Signed-off-by: David Woodhouse

mtd: unify status enum from three headers

2009-09-24T19:55:07Z

nand.h, onenand.h and flashchip.h defined enumeration types for chip status using the same symbolic names. This prevented a board file to include more than one of them. In particular, no nand and onenand platform devices could live in the same file. This patch augments flashchip.h with a few status values in order to cover all cases, so nand.h and onenand.h can use flstate_t without declaring their own status enum. Signed-off-by: Alessandro Rubini Signed-off-by: David Woodhouse

mtd: use bbm.h in nand.h

2009-09-24T19:54:59Z

This consolidates common code in nand.h and bbm.h. The comments and data structures were the same, this keeps the comment from nand.h as it fits 80 columns, while the one in bbm.h did not. Signed-off-by: Alessandro Rubini Signed-off-by: David Woodhouse

mtd: nand: add new ECC mode - ECC_HW_OOB_FIRST

2009-09-19T18:14:54Z

This patch adds the new mode NAND_ECC_HW_OOB_FIRST in the nand code to support 4-bit ECC on TI DaVinci devices with large page (up to 2KiB) NAND chips. This ECC mode is similar to NAND_ECC_HW, with the exception of read_page API that first reads the OOB area, reads the data in chunks, feeds the ECC from OOB area to the ECC hw engine and perform any correction on the data as per the ECC status reported by the engine. "ECC_HW_OOB_FIRST" name suggested by Thomas Gleixner Reviewed-by: David Brownell Signed-off-by: Sneha Narnakaje Signed-off-by: Sandeep Paulraj Cc: Thomas Gleixner Signed-off-by: Andrew Morton Signed-off-by: David Woodhouse

mtd: nand: add "page" parameter to all read_page/read_page_raw APIs

2009-09-19T18:13:47Z

This patch adds a new "page" parameter to all NAND read_page/read_page_raw APIs. The read_page API for the new mode ECC_HW_OOB_FIRST requires the page information to send the READOOB command and read the OOB area before the data area. Reviewed-by: David Brownell Signed-off-by: Sneha Narnakaje Signed-off-by: Sandeep Paulraj Cc: Thomas Gleixner Signed-off-by: Andrew Morton Signed-off-by: David Woodhouse

mtd: plat_nand: allow platform to set partitions

2009-06-05T17:11:55Z

Add optional callback to allow platform to initialize partitions. Static partitions on a nand device could vary depending on the size of the device. This patch allows an optional platform callback to be used to setup this partition information at runtime. Scan order is: 1) chip.part_probe_types 2) chip.set_parts 3) chip.partitions 4) full mtd device (fallback for no partitions) Some of the existing nand drivers could possibly be replaced by the plat_nand driver by using this patch. These include autcpu12.c and ts7250.c drivers. Signed-off-by: H Hartley Sweeten Signed-off-by: Andrew Morton Signed-off-by: Artem Bityutskiy Signed-off-by: David Woodhouse

mtd: plat_nand: add platform probe/remove callbacks

2009-06-05T17:11:13Z

Add optional probe and remove callbacks to the plat_nand driver. Some platforms may require additional setup, such as configuring the memory controller, before the nand device can be accessed. This patch provides an optional callback to handle this setup as well as a callback to teardown the setup. Signed-off-by: H Hartley Sweeten Tested-by: Alexander Clouter Signed-off-by: Andrew Morton Signed-off-by: Artem Bityutskiy Signed-off-by: David Woodhouse

mtd: extend plat_nand for (read|write)_buf

2009-06-05T16:50:52Z

This patch adds (write|read)_buf callbacks to plat_nand. The NAND on the TS-7800 provisioned by the FPGA allows readw() and readl() to be used which gives a 2.5x speed up. To be able to use this from the plat_nand driver a hook for read_buf (and also write_buf whilst we are in there) need to be made available. This patch adds the hook. Signed-off-by: Alexander Clouter Signed-off-by: Artem Bityutskiy Signed-off-by: David Woodhouse

[MTD] [NAND] Add support for 4KiB pages.

2009-04-06T14:01:56Z

Signed-off-by: Thomas Gleixner Signed-off-by: Sebastian Siewior Signed-off-by: David Woodhouse

[MTD] [NAND] remove excess kernel-doc notation

2008-12-10T16:10:40Z

Delete extra kernel-doc notation for struct fields and function parameters that don't exist: Warning(include/linux/mtd/nand.h:428): Excess struct/union/enum/typedef member 'wq' description in 'nand_chip' Warning(include/linux/mtd/nand.h:428): Excess struct/union/enum/typedef member 'datbuf' description in 'nand_chip' Warning(include/linux/mtd/nand.h:428): Excess struct/union/enum/typedef member 'oobbuf' description in 'nand_chip' Warning(include/linux/mtd/nand.h:428): Excess struct/union/enum/typedef member 'oobdirty' description in 'nand_chip' Warning(include/linux/mtd/nand.h:428): Excess struct/union/enum/typedef member 'data_poi' description in 'nand_chip' Warning(drivers/mtd/nand/nand_base.c:2527): Excess function parameter 'maxchips' description in 'nand_scan_tail' Signed-off-by: Randy Dunlap Signed-off-by: Andrew Morton Signed-off-by: David Woodhouse