kernel/drivers/usb/storage/unusual_devs.h, branch linux-6.9.y

usb-storage: Add quirk for incorrect WP on Kingston DT Ultimate 3.0 G3

2023-12-15T13:00:58Z

This flash drive reports write protect during the first mode sense. In the past this was not an issue as the kernel called revalidate twice, thus asking the device for its write protect status twice, with write protect being disabled in the second mode sense. However, since commit 1e029397d12f ("scsi: sd: Reorganize DIF/DIX code to avoid calling revalidate twice") that is no longer the case, thus the device shows up read only. [490891.289495] sd 12:0:0:0: [sdl] Write Protect is on [490891.289497] sd 12:0:0:0: [sdl] Mode Sense: 2b 00 80 08 This does not appear to be a timing issue, as enabling the usbcore quirk USB_QUIRK_DELAY_INIT has no effect on write protect. Fixes: 1e029397d12f ("scsi: sd: Reorganize DIF/DIX code to avoid calling revalidate twice") Cc: stable Signed-off-by: Tasos Sahanidis Acked-by: Alan Stern Reviewed-by: Martin K. Petersen Link: https://lore.kernel.org/r/20231207134441.298131-1-tasos@tasossah.com Signed-off-by: Greg Kroah-Hartman

Revert "usb: storage: Add quirk for Samsung Fit flash"

2022-09-22T13:52:31Z

This reverts commit 86d92f5465958752481269348d474414dccb1552, which fix the timeout issue for "Samsung Fit Flash". But the commit affects not only "Samsung Fit Flash" but also other usb storages that use the same controller and causes severe performance regression. # hdparm -t /dev/sda (without the quirk) Timing buffered disk reads: 622 MB in 3.01 seconds = 206.66 MB/sec # hdparm -t /dev/sda (with the quirk) Timing buffered disk reads: 220 MB in 3.00 seconds = 73.32 MB/sec The commit author mentioned that "Issue was reproduced after device has bad block", so this quirk should be applied when we have the timeout issue with a device that has bad blocks. We revert the commit so that we apply this quirk by adding kernel paramters using a bootloader or other ways when we really need it, without the performance regression with devices that don't have the issue. Signed-off-by: sunghwan jung Link: https://lore.kernel.org/r/20220913114913.3073-1-onenowy@gmail.com Signed-off-by: Greg Kroah-Hartman

usb-storage: Add ignore-residue quirk for NXP PN7462AU

2022-08-18T15:18:05Z

This is USB mass storage primary boot loader for code download on NXP PN7462AU. Without the quirk it is impossible to write whole memory at once as device restarts during the write due to bogus residue values reported. Acked-by: Alan Stern Cc: stable Signed-off-by: Witold Lipieta Link: https://lore.kernel.org/r/20220809112911.462776-1-witold.lipieta@thaumatec.com Signed-off-by: Greg Kroah-Hartman

usb-storage: Add unusual-devs entry for VL817 USB-SATA bridge

2022-01-25T17:42:52Z

Two people have reported (and mentioned numerous other reports on the web) that VIA's VL817 USB-SATA bridge does not work with the uas driver. Typical log messages are: [ 3606.232149] sd 14:0:0:0: [sdg] tag#2 uas_zap_pending 0 uas-tag 1 inflight: CMD [ 3606.232154] sd 14:0:0:0: [sdg] tag#2 CDB: Write(16) 8a 00 00 00 00 00 18 0c c9 80 00 00 00 80 00 00 [ 3606.306257] usb 4-4.4: reset SuperSpeed Plus Gen 2x1 USB device number 11 using xhci_hcd [ 3606.328584] scsi host14: uas_eh_device_reset_handler success Surprisingly, the devices do seem to work okay for some other people. The cause of the differing behaviors is not known. In the hope of getting the devices to work for the most users, even at the possible cost of degraded performance for some, this patch adds an unusual_devs entry for the VL817 to block it from binding to the uas driver by default. Users will be able to override this entry by means of a module parameter, if they want. CC: Reported-by: DocMAX Reported-and-tested-by: Thomas Weißschuh Signed-off-by: Alan Stern Link: https://lore.kernel.org/r/Ye8IsK2sjlEv1rqU@rowland.harvard.edu Signed-off-by: Greg Kroah-Hartman

usb-storage: Add compatibility quirk flags for iODD 2531/2541

2021-10-18T15:05:34Z

These drive enclosures have firmware bugs that make it impossible to mount a new virtual ISO image after Linux ejects the old one if the device is locked by Linux. Windows bypasses this problem by the fact that they do not lock the device. Add a quirk to disable device locking for these drive enclosures. Acked-by: Alan Stern Signed-off-by: James Buren Cc: stable Link: https://lore.kernel.org/r/20211014015504.2695089-1-braewoods+lkml@braewoods.net Signed-off-by: Greg Kroah-Hartman

usb-storage: Add quirk for ScanLogic SL11R-IDE older than 2.6c

2021-09-21T14:37:52Z

ScanLogic SL11R-IDE with firmware older than 2.6c (the latest one) has broken tag handling, preventing the device from working at all: usb 1-1: new full-speed USB device number 2 using uhci_hcd usb 1-1: New USB device found, idVendor=04ce, idProduct=0002, bcdDevice= 2.60 usb 1-1: New USB device strings: Mfr=1, Product=1, SerialNumber=0 usb 1-1: Product: USB Device usb 1-1: Manufacturer: USB Device usb-storage 1-1:1.0: USB Mass Storage device detected scsi host2: usb-storage 1-1:1.0 usbcore: registered new interface driver usb-storage usb 1-1: reset full-speed USB device number 2 using uhci_hcd usb 1-1: reset full-speed USB device number 2 using uhci_hcd usb 1-1: reset full-speed USB device number 2 using uhci_hcd usb 1-1: reset full-speed USB device number 2 using uhci_hcd Add US_FL_BULK_IGNORE_TAG to fix it. Also update my e-mail address. 2.6c is the only firmware that claims Linux compatibility. The firmware can be upgraded using ezotgdbg utility: https://github.com/asciilifeform/ezotgdbg Acked-by: Alan Stern Signed-off-by: Ondrej Zary Cc: stable Link: https://lore.kernel.org/r/20210913210106.12717-1-linux@zary.sk Signed-off-by: Greg Kroah-Hartman

usb-storage: Add quirk to defeat Kindle's automatic unload

2021-03-17T20:30:15Z

Matthias reports that the Amazon Kindle automatically removes its emulated media if it doesn't receive another SCSI command within about one second after a SYNCHRONIZE CACHE. It does so even when the host has sent a PREVENT MEDIUM REMOVAL command. The reason for this behavior isn't clear, although it's not hard to make some guesses. At any rate, the results can be unexpected for anyone who tries to access the Kindle in an unusual fashion, and in theory they can lead to data loss (for example, if one file is closed and synchronized while other files are still in the middle of being written). To avoid such problems, this patch creates a new usb-storage quirks flag telling the driver always to issue a REQUEST SENSE following a SYNCHRONIZE CACHE command, and adds an unusual_devs entry for the Kindle with the flag set. This is sufficient to prevent the Kindle from doing its automatic unload, without interfering with proper operation. Another possible way to deal with this would be to increase the frequency of TEST UNIT READY polling that the kernel normally carries out for removable-media storage devices. However that would increase the overall load on the system and it is not as reliable, because the user can override the polling interval. Changing the driver's behavior is safer and has minimal overhead. CC: Reported-and-tested-by: Matthias Schwarzott Signed-off-by: Alan Stern Link: https://lore.kernel.org/r/20210317190654.GA497856@rowland.harvard.edu Signed-off-by: Greg Kroah-Hartman

USB: Ignore UAS for JMicron JMS567 ATA/ATAPI Bridge

2020-08-27T07:26:00Z

This device does not support UAS properly and a similar entry already exists in drivers/usb/storage/unusual_uas.h. Without this patch, storage_probe() defers the handling of this device to UAS, which cannot handle it either. Tested-by: Brice Goglin Fixes: bc3bdb12bbb3 ("usb-storage: Disable UAS on JMicron SATA enclosure") Acked-by: Alan Stern CC: Signed-off-by: Cyril Roelandt Link: https://lore.kernel.org/r/20200825212231.46309-1-tipecaml@gmail.com Signed-off-by: Greg Kroah-Hartman

USB: storage: replace HTTP links with HTTPS ones

2020-07-09T16:06:12Z

Rationale: Reduces attack surface on kernel devs opening the links for MITM as HTTPS traffic is much harder to manipulate. Deterministic algorithm: For each file: If not .svg: For each line: If doesn't contain `\bxmlns\b`: For each link, `\bhttp://[^# \t\r\n]*(?:\w|/)`: If neither `\bgnu\.org/license`, nor `\bmozilla\.org/MPL\b`: If both the HTTP and HTTPS versions return 200 OK and serve the same content: Replace HTTP with HTTPS. Signed-off-by: Alexander A. Klimov Link: https://lore.kernel.org/r/20200708184903.17350-1-grandmaster@al2klimov.de Signed-off-by: Greg Kroah-Hartman

Merge 5.7-rc3 into usb-next

2020-04-27T07:32:30Z

We need the USB fixes in here too. Signed-off-by: Greg Kroah-Hartman