kernel/drivers/net/wireless/ath/ath11k/pcic.c, branch linux-6.2.y

Merge ath-next from git://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git

2022-10-29T05:25:50Z

ath.git patches for v6.2. Major changes: ath11k * support configuring channel dwell time during scan

Merge tag 'wireless-next-2022-09-30' of git://git.kernel.org/pub/scm/linux/kernel/git/wireless/wireless-next

2022-09-30T17:07:31Z

Kalle Valo says: ==================== wireless-next patches for v6.1 Few stack changes and lots of driver changes in this round. brcmfmac has more activity as usual and it gets new hardware support. ath11k improves WCN6750 support and also other smaller features. And of course changes all over. Note: in early September wireless tree was merged to wireless-next to avoid some conflicts with mac80211 patches, this shouldn't cause any problems but wanted to mention anyway. Major changes: mac80211 - refactoring and preparation for Wi-Fi 7 Multi-Link Operation (MLO) feature continues brcmfmac - support CYW43439 SDIO chipset - support BCM4378 on Apple platforms - support CYW89459 PCIe chipset rtw89 - more work to get rtw8852c supported - P2P support - support for enabling and disabling MSDU aggregation via nl80211 mt76 - tx status reporting improvements ath11k - cold boot calibration support on WCN6750 - Target Wake Time (TWT) debugfs support for STA interface - support to connect to a non-transmit MBSSID AP profile - enable remain-on-channel support on WCN6750 - implement SRAM dump debugfs interface - enable threaded NAPI on all hardware - WoW support for WCN6750 - support to provide transmit power from firmware via nl80211 - support to get power save duration for each client - spectral scan support for 160 MHz wcn36xx - add SNR from a received frame as a source of system entropy * tag 'wireless-next-2022-09-30' of git://git.kernel.org/pub/scm/linux/kernel/git/wireless/wireless-next: (231 commits) wifi: rtl8xxxu: Improve rtl8xxxu_queue_select wifi: rtl8xxxu: Fix AIFS written to REG_EDCA_*_PARAM wifi: rtl8xxxu: gen2: Enable 40 MHz channel width wifi: rtw89: 8852b: configure DLE mem wifi: rtw89: check DLE FIFO size with reserved size wifi: rtw89: mac: correct register of report IMR wifi: rtw89: pci: set power cut closed for 8852be wifi: rtw89: pci: add to do PCI auto calibration wifi: rtw89: 8852b: implement chip_ops::{enable,disable}_bb_rf wifi: rtw89: add DMA busy checking bits to chip info wifi: rtw89: mac: define DMA channel mask to avoid unsupported channels wifi: rtw89: pci: mask out unsupported TX channels iwlegacy: Replace zero-length arrays with DECLARE_FLEX_ARRAY() helper ipw2x00: Replace zero-length array with DECLARE_FLEX_ARRAY() helper wifi: iwlwifi: Track scan_cmd allocation size explicitly brcmfmac: Remove the call to "dtim_assoc" IOVAR brcmfmac: increase dcmd maximum buffer size brcmfmac: Support 89459 pcie brcmfmac: increase default max WOWL patterns to 16 cw1200: fix incorrect check to determine if no element is found in list ... ==================== Link: https://lore.kernel.org/r/20220930150413.A7984C433D6@smtp.kernel.org Signed-off-by: Jakub Kicinski

wifi: ath11k: Don't exit on wakeup failure

2022-09-30T06:33:06Z

Currently, ath11k_pcic_read() returns an error if wakeup() fails, this makes firmware crash debug quite hard because we can get nothing. Change to go ahead on wakeup failure, in that case we still may get something valid to check. There should be no mislead due to incorrect content because we are aware of the failure with the log printed. Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1 Signed-off-by: Baochen Qiang Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220928015140.5431-1-quic_bqiang@quicinc.com

net: drop the weight argument from netif_napi_add

2022-09-29T01:57:14Z

We tell driver developers to always pass NAPI_POLL_WEIGHT as the weight to netif_napi_add(). This may be confusing to newcomers, drop the weight argument, those who really need to tweak the weight can use netif_napi_add_weight(). Acked-by: Marc Kleine-Budde # for CAN Link: https://lore.kernel.org/r/20220927132753.750069-1-kuba@kernel.org Signed-off-by: Jakub Kicinski

wifi: ath11k: Add WoW support for WCN6750

2022-09-19T13:03:34Z

Add support for WoW on WCN6750 chipset. Unlike other chips where WoW exit happens after sending WoW wakeup WMI command, exit from WoW suspend in the case of WCN6750 happens upon sending a WoW exit SMP2P (Shared memory point to point) message to the firmware. Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1 Signed-off-by: Manikanta Pubbisetty Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220902112520.24804-3-quic_mpubbise@quicinc.com

wifi: ath11k: Enable threaded NAPI

2022-09-10T06:27:53Z

Enable threaded NAPI on all ath11k targets. Unlike traditional NAPI poll which runs in softirq context and on the core which scheduled the NAPI, threaded NAPI makes use of kernel threads which are under direct control of the scheduler and helps in balancing the NAPI processing load across multiple CPUs thereby improving throughput. In the case of WCN6750, enabling threaded NAPI has improved 160 MHz RX throughput by nearly 400 Mbps. Similar gains can be expected on other ath11k devices as well. Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1 Signed-off-by: Manikanta Pubbisetty Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220905071805.31625-2-quic_mpubbise@quicinc.com

wifi: ath11k: implement SRAM dump debugfs interface

2022-09-10T06:26:18Z

On-board SRAM contains valuable information for firmware debugging so add a new file named "sram" to debugfs with which we can dump SRAM content using following the following: cp /sys/kernel/debug/ath11k/wcn6855\ hw2.0/sram /tmp/sram Currently this feature is enabled for QCA6390 and WCN6855. Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1 Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1 Signed-off-by: Baochen Qiang Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220802075533.1744-3-quic_bqiang@quicinc.com

wifi: ath11k: Split PCI write/read functions

2022-09-10T06:26:18Z

ath11k_pcic_write32/read32 tries to do wake up before doing actual write/read work, which means each time a u32 is written/read, wake up is performed. This is not necessary in case where we do a large amount of write/read, because only one time of wake up is needed. So split each one into two parts, the first part does wake up and release, and the second one does actual write/read work. Tested-on: QCA6390 hw2.0 PCI WLAN.HST.1.0.1-01740-QCAHSTSWPLZ_V2_TO_X86-1 Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1 Signed-off-by: Baochen Qiang Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220802075533.1744-2-quic_bqiang@quicinc.com

wifi: ath11k: Fix register write failure on QCN9074

2022-07-27T10:04:22Z

Commit 56c8ccf331bd ("ath11k: Add register access logic for WCN6750") regressed QCN9074. With the above mentioned commit, writes are failing for some registers on QCN9074 although the device seems to work normally. ath11k_pci 0000:03:00.0: failed to set pcie link register0x01e0e0a8: 0xffffffff != 0x00000010 ath11k_pci 0000:03:00.0: failed to set sysclk: -110 PCIe devices in ath11k (QCA6390, WCN6855, QCN9074, WCN6750) use window concept for register accesses. There are two schemes, dynamic & static window. In dynamic window scheme, a single window(region in the BAR) is mapped either to CE or DP register windows at any give time. QCA6390 & WCN6855 follow this scheme for register accesses. In static window scheme, CE & DP register windows are statically mapped to separate regions with in the BAR so that there is no switching of register windows between CE & DP register accesses. QCN9074 & WCN6750 follow this scheme although the window start offsets are different for QCN9074 & WCN6750. QCN9074 uses 3rd & 2nd window for DP & CE register accesses respectively whereas WCN6750 uses 1st & 2nd window for DP & CE. In QCN9074, along with 2nd & 3rd windows, 1st window is also used for certain configurations which commit 56c8ccf331bd ("ath11k: Add register access logic for WCN6750") did not account for and hence the regression. Fix this by going back to the original way of accessing the registers on QCN9074. Since this diverges from WCN6750 way of accessing registers, it is required to register window_read32/window_write32() pci_ops for WCN6750. We can also get rid of dp_window_idx & ce_window_idx members in hw_params, so remove them. Also add a new API ath11k_pcic_register_pci_ops() for registering pci_ops to the ath11k core. This API checks for mandatory pci_ops() and reports error if those are missing. Also initialize unused pci_ops to NULL. Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1 Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.6.0.1-00861-QCAHKSWPL_SILICONZ-1 Fixes: 56c8ccf331bd ("ath11k: Add register access logic for WCN6750") Reported-by: Maxime Bizon Tested-by: Maxime Bizon Signed-off-by: Manikanta Pubbisetty Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220608062954.27792-1-quic_mpubbise@quicinc.com

ath11k: Add support for WCN6750 device

2022-05-02T13:59:08Z

WCN6750 is non-DBS 2x2 11AX chipset. Unlike QCA6390 which is a DBS (dual band simultaneous) solution (2 LMACs), WCN6750 has a single LMAC supporting 2G, 5G and 6G bands but will operate only on one band at any given point. WCN6750 is a PCIe based solution, but it is attached to the WPSS (Wireless Processor SubSystem) Q6 processor, hence it is enumerated by the Q6 processor. It is registered to the APSS processor (Application Processor SubSystem) as a platform device(AHB) and remoteproc APIs are used to boot up or shutdown the device like other AHB devices. Also, Device information like BAR and it's size is not known to the APSS processor as the chip is enumerated by WPSS Q6. These details are fetched over QMI. STA and AP modes are supported. Verified basic connectivity and ping in both the modes. An important point to note is that though WCN6750 is a PCIe device, it cannot be attached to any other platform except on Qualcomm Snapdragon SoCs due to the aforementioned reasons. Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1 Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1 Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.5.0.1-01100-QCAHKSWPL_SILICONZ-1 Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.4.0.1-00192-QCAHKSWPL_SILICONZ-1 Signed-off-by: Manikanta Pubbisetty Signed-off-by: Kalle Valo Link: https://lore.kernel.org/r/20220429170502.20080-10-quic_mpubbise@quicinc.com