kernel/drivers/net/ethernet/microchip/Kconfig, branch linux-rolling-stable

microchip: lan865x: add driver support for Microchip's LAN865X MAC-PHY

2024-09-12T03:53:46Z

The LAN8650/1 is designed to conform to the OPEN Alliance 10BASE-T1x MAC-PHY Serial Interface specification, Version 1.1. The IEEE Clause 4 MAC integration provides the low pin count standard SPI interface to any microcontroller therefore providing Ethernet functionality without requiring MAC integration within the microcontroller. The LAN8650/1 operates as an SPI client supporting SCLK clock rates up to a maximum of 25 MHz. This SPI interface supports the transfer of both data (Ethernet frames) and control (register access). By default, the chunk data payload is 64 bytes in size. The Ethernet Media Access Controller (MAC) module implements a 10 Mbps half duplex Ethernet MAC, compatible with the IEEE 802.3 standard. 10BASE-T1S physical layer transceiver integrated is into the LAN8650/1. The PHY and MAC are connected via an internal Media Independent Interface (MII). Reviewed-by: Andrew Lunn Signed-off-by: Parthiban Veerasooran Link: https://patch.msgid.link/20240909082514.262942-14-Parthiban.Veerasooran@microchip.com Signed-off-by: Jakub Kicinski

net: lan743x: Migrate phylib to phylink

2024-09-11T10:06:12Z

Migrate phy support from phylib to phylink. Reviewed-by: Andrew Lunn Reviewed-by: Maxime Chevallier Signed-off-by: Raju Lakkaraju Signed-off-by: David S. Miller

net: microchip: add FDMA library

2024-09-04T10:53:49Z

Add new FDMA library for interacting with the FDMA engine on Microchip Sparx5 and lan966x switch chips, in an effort to reduce duplicate code and provide a common set of symbols and functions. Signed-off-by: Daniel Machon Reviewed-by: Steen Hegelund Reviewed-by: Jens Emil Schulz Østergaard Reviewed-by: Horatiu Vultur Signed-off-by: David S. Miller

net: lan743x: also select PHYLIB

2023-10-05T16:10:18Z

Since FIXED_PHY depends on PHYLIB, PHYLIB needs to be set to avoid a kconfig warning: WARNING: unmet direct dependencies detected for FIXED_PHY Depends on [n]: NETDEVICES [=y] && PHYLIB [=n] Selected by [y]: - LAN743X [=y] && NETDEVICES [=y] && ETHERNET [=y] && NET_VENDOR_MICROCHIP [=y] && PCI [=y] && PTP_1588_CLOCK_OPTIONAL [=y] Fixes: 73c4d1b307ae ("net: lan743x: select FIXED_PHY") Signed-off-by: Randy Dunlap Reported-by: kernel test robot Closes: lore.kernel.org/r/202309261802.JPbRHwti-lkp@intel.com Cc: Bryan Whitehead Cc: UNGLinuxDriver@microchip.com Reviewed-by: Simon Horman Tested-by: Simon Horman # build-tested Link: https://lore.kernel.org/r/20231002193544.14529-1-rdunlap@infradead.org Signed-off-by: Jakub Kicinski

net: lan743x: select FIXED_PHY

2023-07-09T10:23:47Z

The blamed commit introduces usage of fixed_phy_register() but not a corresponding dependency on FIXED_PHY. This can result in a build failure. s390-linux-ld: drivers/net/ethernet/microchip/lan743x_main.o: in function `lan743x_phy_open': drivers/net/ethernet/microchip/lan743x_main.c:1514: undefined reference to `fixed_phy_register' Fixes: 624864fbff92 ("net: lan743x: add fixed phy support for LAN7431 device") Cc: stable@vger.kernel.org Reported-by: Randy Dunlap Closes: https://lore.kernel.org/netdev/725bf1c5-b252-7d19-7582-a6809716c7d6@infradead.org/ Reviewed-by: Randy Dunlap Tested-by: Randy Dunlap # build-tested Signed-off-by: Simon Horman Signed-off-by: David S. Miller

net: microchip: sparx5: Adding initial VCAP API support

2022-10-24T09:37:42Z

This provides the initial VCAP API framework and Sparx5 specific VCAP implementation. When the Sparx5 Switchdev driver is initialized it will also initialize its VCAP module, and this hooks up the concrete Sparx5 VCAP model to the VCAP API, so that the VCAP API knows what VCAP instances are available. Signed-off-by: Steen Hegelund Signed-off-by: David S. Miller

net: lan966x: add the basic lan966x driver

2021-11-29T12:58:38Z

This patch adds basic SwitchDev driver framework for lan966x. It includes only the IO range mapping and probing of the switch. Signed-off-by: Horatiu Vultur Signed-off-by: David S. Miller

ethernet: fix PTP_1588_CLOCK dependencies

2021-08-14T00:49:05Z

The 'imply' keyword does not do what most people think it does, it only politely asks Kconfig to turn on another symbol, but does not prevent it from being disabled manually or built as a loadable module when the user is built-in. In the ICE driver, the latter now causes a link failure: aarch64-linux-ld: drivers/net/ethernet/intel/ice/ice_main.o: in function `ice_eth_ioctl': ice_main.c:(.text+0x13b0): undefined reference to `ice_ptp_get_ts_config' ice_main.c:(.text+0x13b0): relocation truncated to fit: R_AARCH64_CALL26 against undefined symbol `ice_ptp_get_ts_config' aarch64-linux-ld: ice_main.c:(.text+0x13bc): undefined reference to `ice_ptp_set_ts_config' ice_main.c:(.text+0x13bc): relocation truncated to fit: R_AARCH64_CALL26 against undefined symbol `ice_ptp_set_ts_config' aarch64-linux-ld: drivers/net/ethernet/intel/ice/ice_main.o: in function `ice_prepare_for_reset': ice_main.c:(.text+0x31fc): undefined reference to `ice_ptp_release' ice_main.c:(.text+0x31fc): relocation truncated to fit: R_AARCH64_CALL26 against undefined symbol `ice_ptp_release' aarch64-linux-ld: drivers/net/ethernet/intel/ice/ice_main.o: in function `ice_rebuild': This is a recurring problem in many drivers, and we have discussed it several times befores, without reaching a consensus. I'm providing a link to the previous email thread for reference, which discusses some related problems. To solve the dependency issue better than the 'imply' keyword, introduce a separate Kconfig symbol "CONFIG_PTP_1588_CLOCK_OPTIONAL" that any driver can depend on if it is able to use PTP support when available, but works fine without it. Whenever CONFIG_PTP_1588_CLOCK=m, those drivers are then prevented from being built-in, the same way as with a 'depends on PTP_1588_CLOCK || !PTP_1588_CLOCK' dependency that does the same trick, but that can be rather confusing when you first see it. Since this should cover the dependencies correctly, the IS_REACHABLE() hack in the header is no longer needed now, and can be turned back into a normal IS_ENABLED() check. Any driver that gets the dependency wrong will now cause a link time failure rather than being unable to use PTP support when that is in a loadable module. However, the two recently added ptp_get_vclocks_index() and ptp_convert_timestamp() interfaces are only called from builtin code with ethtool and socket timestamps, so keep the current behavior by stubbing those out completely when PTP is in a loadable module. This should be addressed properly in a follow-up. As Richard suggested, we may want to actually turn PTP support into a 'bool' option later on, preventing it from being a loadable module altogether, which would be one way to solve the problem with the ethtool interface. Fixes: 06c16d89d2cb ("ice: register 1588 PTP clock device object for E810 devices") Link: https://lore.kernel.org/netdev/20210804121318.337276-1-arnd@kernel.org/ Link: https://lore.kernel.org/netdev/CAK8P3a06enZOf=XyZ+zcAwBczv41UuCTz+=0FMf2gBz1_cOnZQ@mail.gmail.com/ Link: https://lore.kernel.org/netdev/CAK8P3a3=eOxE-K25754+fB_-i_0BZzf9a9RfPTX3ppSwu9WZXw@mail.gmail.com/ Link: https://lore.kernel.org/netdev/20210726084540.3282344-1-arnd@kernel.org/ Acked-by: Shannon Nelson Acked-by: Jacob Keller Acked-by: Richard Cochran Reviewed-by: Vladimir Oltean Signed-off-by: Arnd Bergmann Link: https://lore.kernel.org/r/20210812183509.1362782-1-arnd@kernel.org Signed-off-by: Jakub Kicinski

net: sparx5: add the basic sparx5 driver

2021-06-24T18:28:12Z

This adds the Sparx5 basic SwitchDev driver framework with IO range mapping, switch device detection and core clock configuration. Support for ports, phylink, netdev, mactable etc. are in the following patches. Signed-off-by: Steen Hegelund Signed-off-by: Bjarni Jonasson Signed-off-by: Lars Povlsen Reviewed-by: Philipp Zabel Signed-off-by: David S. Miller

ethernet: select CONFIG_CRC32 as needed

2020-12-04T22:42:21Z

A number of ethernet drivers require crc32 functionality to be avaialable in the kernel, causing a link error otherwise: arm-linux-gnueabi-ld: drivers/net/ethernet/agere/et131x.o: in function `et1310_setup_device_for_multicast': et131x.c:(.text+0x5918): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/cadence/macb_main.o: in function `macb_start_xmit': macb_main.c:(.text+0x4b88): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/faraday/ftgmac100.o: in function `ftgmac100_set_rx_mode': ftgmac100.c:(.text+0x2b38): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/freescale/fec_main.o: in function `set_multicast_list': fec_main.c:(.text+0x6120): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/freescale/fman/fman_dtsec.o: in function `dtsec_add_hash_mac_address': fman_dtsec.c:(.text+0x830): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/freescale/fman/fman_dtsec.o:fman_dtsec.c:(.text+0xb68): more undefined references to `crc32_le' follow arm-linux-gnueabi-ld: drivers/net/ethernet/netronome/nfp/nfpcore/nfp_hwinfo.o: in function `nfp_hwinfo_read': nfp_hwinfo.c:(.text+0x250): undefined reference to `crc32_be' arm-linux-gnueabi-ld: nfp_hwinfo.c:(.text+0x288): undefined reference to `crc32_be' arm-linux-gnueabi-ld: drivers/net/ethernet/netronome/nfp/nfpcore/nfp_resource.o: in function `nfp_resource_acquire': nfp_resource.c:(.text+0x144): undefined reference to `crc32_be' arm-linux-gnueabi-ld: nfp_resource.c:(.text+0x158): undefined reference to `crc32_be' arm-linux-gnueabi-ld: drivers/net/ethernet/nxp/lpc_eth.o: in function `lpc_eth_set_multicast_list': lpc_eth.c:(.text+0x1934): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/rocker/rocker_ofdpa.o: in function `ofdpa_flow_tbl_do': rocker_ofdpa.c:(.text+0x2e08): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/rocker/rocker_ofdpa.o: in function `ofdpa_flow_tbl_del': rocker_ofdpa.c:(.text+0x3074): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/rocker/rocker_ofdpa.o: in function `ofdpa_port_fdb': arm-linux-gnueabi-ld: drivers/net/ethernet/mellanox/mlx5/core/steering/dr_ste.o: in function `mlx5dr_ste_calc_hash_index': dr_ste.c:(.text+0x354): undefined reference to `crc32_le' arm-linux-gnueabi-ld: drivers/net/ethernet/microchip/lan743x_main.o: in function `lan743x_netdev_set_multicast': lan743x_main.c:(.text+0x5dc4): undefined reference to `crc32_le' Add the missing 'select CRC32' entries in Kconfig for each of them. Signed-off-by: Arnd Bergmann Acked-by: Nicolas Ferre Acked-by: Madalin Bucur Acked-by: Mark Einon Acked-by: Simon Horman Link: https://lore.kernel.org/r/20201203232114.1485603-1-arnd@kernel.org Signed-off-by: Jakub Kicinski