kernel/drivers/net/ethernet/intel/e1000e/ich8lan.c, branch linux-6.18.y

e1000e: clear DPG_EN after reset to avoid autonomous power-gating

2026-03-12T11:09:49Z

[ Upstream commit 0942fc6d324eb9c6b16187b2aa994c0823557f06 ] Panther Lake systems introduced an autonomous power gating feature for the integrated Gigabit Ethernet in shutdown state (S5) state. As part of it, the reset value of DPG_EN bit was changed to 1. Clear this bit after performing hardware reset to avoid errors such as Tx/Rx hangs, or packet loss/corruption. Fixes: 0c9183ce61bc ("e1000e: Add support for the next LOM generation") Signed-off-by: Vitaly Lifshits Reviewed-by: Aleksandr Loktionov Tested-by: Avigail Dahan Reviewed-by: Paul Menzel Signed-off-by: Tony Nguyen Signed-off-by: Sasha Levin

e1000e: disregard NVM checksum on tgp when valid checksum bit is not set

2025-07-21T17:31:09Z

As described by Vitaly Lifshits: > Starting from Tiger Lake, LAN NVM is locked for writes by SW, so the > driver cannot perform checksum validation and correction. This means > that all NVM images must leave the factory with correct checksum and > checksum valid bit set. Since Tiger Lake devices were the first to have > this lock, some systems in the field did not meet this requirement. > Therefore, for these transitional devices we skip checksum update and > verification, if the valid bit is not set. Signed-off-by: Jacek Kowalski Reviewed-by: Simon Horman Reviewed-by: Vitaly Lifshits Fixes: 4051f68318ca9 ("e1000e: Do not take care about recovery NVM checksum") Cc: stable@vger.kernel.org Tested-by: Mor Bar-Gabay Signed-off-by: Tony Nguyen

e1000e: change k1 configuration on MTP and later platforms

2025-04-02T15:51:41Z

Starting from Meteor Lake, the Kumeran interface between the integrated MAC and the I219 PHY works at a different frequency. This causes sporadic MDI errors when accessing the PHY, and in rare circumstances could lead to packet corruption. To overcome this, introduce minor changes to the Kumeran idle state (K1) parameters during device initialization. Hardware reset reverts this configuration, therefore it needs to be applied in a few places. Fixes: cc23f4f0b6b9 ("e1000e: Add support for Meteor Lake") Signed-off-by: Vitaly Lifshits Tested-by: Avigail Dahan Signed-off-by: Tony Nguyen

e1000e: Remove Meteor Lake SMBUS workarounds

2024-11-04T21:09:34Z

This is a partial revert to commit 76a0a3f9cc2f ("e1000e: fix force smbus during suspend flow"). That commit fixed a sporadic PHY access issue but introduced a regression in runtime suspend flows. The original issue on Meteor Lake systems was rare in terms of the reproduction rate and the number of the systems affected. After the integration of commit 0a6ad4d9e169 ("e1000e: avoid failing the system during pm_suspend"), PHY access loss can no longer cause a system-level suspend failure. As it only occurs when the LAN cable is disconnected, and is recovered during system resume flow. Therefore, its functional impact is low, and the priority is given to stabilizing runtime suspend. Fixes: 76a0a3f9cc2f ("e1000e: fix force smbus during suspend flow") Signed-off-by: Vitaly Lifshits Tested-by: Avigail Dahan Signed-off-by: Tony Nguyen

e1000e: fix force smbus during suspend flow

2024-07-11T02:06:17Z

Commit 861e8086029e ("e1000e: move force SMBUS from enable ulp function to avoid PHY loss issue") resolved a PHY access loss during suspend on Meteor Lake consumer platforms, but it affected corporate systems incorrectly. A better fix, working for both consumer and corporate systems, was proposed in commit bfd546a552e1 ("e1000e: move force SMBUS near the end of enable_ulp function"). However, it introduced a regression on older devices, such as [8086:15B8], [8086:15F9], [8086:15BE]. This patch aims to fix the secondary regression, by limiting the scope of the changes to Meteor Lake platforms only. Fixes: bfd546a552e1 ("e1000e: move force SMBUS near the end of enable_ulp function") Reported-by: Todd Brandt Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218940 Reported-by: Dieter Mummenschanz Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218936 Signed-off-by: Vitaly Lifshits Tested-by: Mor Bar-Gabay (A Contingent Worker at Intel) Signed-off-by: Tony Nguyen Reviewed-by: Simon Horman Link: https://patch.msgid.link/20240709203123.2103296-1-anthony.l.nguyen@intel.com Signed-off-by: Jakub Kicinski

e1000e: move force SMBUS near the end of enable_ulp function

2024-05-30T01:56:30Z

The commit 861e8086029e ("e1000e: move force SMBUS from enable ulp function to avoid PHY loss issue") introduces a regression on PCH_MTP_I219_LM18 (PCIID: 0x8086550A). Without the referred commit, the ethernet works well after suspend and resume, but after applying the commit, the ethernet couldn't work anymore after the resume and the dmesg shows that the NIC link changes to 10Mbps (1000Mbps originally): [ 43.305084] e1000e 0000:00:1f.6 enp0s31f6: NIC Link is Up 10 Mbps Full Duplex, Flow Control: Rx/Tx Without the commit, the force SMBUS code will not be executed if "return 0" or "goto out" is executed in the enable_ulp(), and in my case, the "goto out" is executed since FWSM_FW_VALID is set. But after applying the commit, the force SMBUS code will be ran unconditionally. Here move the force SMBUS code back to enable_ulp() and put it immediately ahead of hw->phy.ops.release(hw), this could allow the longest settling time as possible for interface in this function and doesn't change the original code logic. The issue was found on a Lenovo laptop with the ethernet hw as below: 00:1f.6 Ethernet controller [0200]: Intel Corporation Device [8086:550a] (rev 20). And this patch is verified (cable plug and unplug, system suspend and resume) on Lenovo laptops with ethernet hw: [8086:550a], [8086:550b], [8086:15bb], [8086:15be], [8086:1a1f], [8086:1a1c] and [8086:0dc7]. Fixes: 861e8086029e ("e1000e: move force SMBUS from enable ulp function to avoid PHY loss issue") Signed-off-by: Hui Wang Acked-by: Vitaly Lifshits Tested-by: Naama Meir Reviewed-by: Simon Horman Reviewed-by: Paul Menzel Signed-off-by: Tony Nguyen Tested-by: Zhang Rui Signed-off-by: Jacob Keller Link: https://lore.kernel.org/r/20240528-net-2024-05-28-intel-net-fixes-v1-1-dc8593d2bbc6@intel.com Signed-off-by: Jakub Kicinski

e1000e: move force SMBUS from enable ulp function to avoid PHY loss issue

2024-03-27T18:44:34Z

Forcing SMBUS inside the ULP enabling flow leads to sporadic PHY loss on some systems. It is suspected to be caused by initiating PHY transactions before the interface settles. Separating this configuration from the ULP enabling flow and moving it to the shutdown function allows enough time for the interface to settle and avoids adding a delay. Fixes: 6607c99e7034 ("e1000e: i219 - fix to enable both ULP and EEE in Sx state") Co-developed-by: Dima Ruinskiy Signed-off-by: Dima Ruinskiy Signed-off-by: Vitaly Lifshits Tested-by: Naama Meir Signed-off-by: Tony Nguyen

e1000e: Workaround for sporadic MDI error on Meteor Lake systems

2024-03-27T18:44:20Z

On some Meteor Lake systems accessing the PHY via the MDIO interface may result in an MDI error. This issue happens sporadically and in most cases a second access to the PHY via the MDIO interface results in success. As a workaround, introduce a retry counter which is set to 3 on Meteor Lake systems. The driver will only return an error if 3 consecutive PHY access attempts fail. The retry mechanism is disabled in specific flows, where MDI errors are expected. Fixes: cc23f4f0b6b9 ("e1000e: Add support for Meteor Lake") Suggested-by: Nikolay Mushayev Co-developed-by: Nir Efrati Signed-off-by: Nir Efrati Signed-off-by: Vitaly Lifshits Tested-by: Naama Meir Signed-off-by: Tony Nguyen

intel: legacy: Partial revert of field get conversion

2024-03-05T18:07:04Z

Refactoring of the field get conversion introduced a regression in the legacy Wake On Lan from a magic packet with i219 devices. Rx address copied not correctly from MAC to PHY with FIELD_GET macro. Fixes: b9a452545075 ("intel: legacy: field get conversion") Suggested-by: Vitaly Lifshits Signed-off-by: Sasha Neftin Tested-by: Naama Meir Signed-off-by: Tony Nguyen

intel: legacy: field get conversion

2023-12-18T19:20:43Z

Refactor several older Intel drivers to use FIELD_GET(), which reduces lines of code and adds clarity of intent. This code was generated by the following coccinelle/spatch script and then manually repaired. @get@ constant shift,mask; type T; expression a; @@ ( -((T)((a) & mask) >> shift) +FIELD_GET(mask, a) and applied via: spatch --sp-file field_prep.cocci --in-place --dir \ drivers/net/ethernet/intel/ Cc: Julia Lawall CC: Alexander Lobakin Reviewed-by: Marcin Szycik Reviewed-by: Simon Horman Signed-off-by: Jesse Brandeburg Tested-by: Pucha Himasekhar Reddy (A Contingent worker at Intel) Signed-off-by: Tony Nguyen