kernel/drivers/net/ethernet/emulex, branch linux-4.16.y

be2net: Fix error detection logic for BE3

2018-06-11T20:48:14Z

[ Upstream commit d2c2725c2cdbcc108a191f50953d31c7b6556761 ] Check for 0xE00 (RECOVERABLE_ERR) along with ARMFW UE (0x0) in be_detect_error() to know whether the error is valid error or not Fixes: 673c96e5a ("be2net: Fix UE detection logic for BE3") Signed-off-by: Suresh Reddy Signed-off-by: David S. Miller Signed-off-by: Greg Kroah-Hartman

be2net: Handle transmit completion errors in Lancer

2018-02-06T16:48:33Z

If the driver receives a TX CQE with status as 0x1 or 0x9 or 0xb, the completion indexes should not be used. The driver must stop consuming CQEs from this TXQ/CQ. The TXQ from this point on-wards to be in a bad state. Driver should destroy and recreate the TXQ. 0x1: LANCER_TX_COMP_LSO_ERR 0x9 LANCER_TX_COMP_SGE_ERR 0xb: LANCER_TX_COMP_PARITY_ERR Reset the adapter if driver sees this error in TX completion. Also adding sge error counter in ethtool stats. Signed-off-by: Suresh Reddy Signed-off-by: David S. Miller

be2net: Fix HW stall issue in Lancer

2018-02-06T16:48:17Z

Lancer HW cannot handle a TSO packet with a single segment. Disable TSO/GSO for such packets. Signed-off-by: Suresh Reddy Signed-off-by: David S. Miller

be2net: remove redundant initialization of 'head' and pointer txq

2018-02-01T14:43:00Z

Variable head is initialized to a value that is never read and is being updated to a new value a few lines later, hence this initialization is redundant and can be safely removed as well as the now unused pointer txq. Cleans up clang warning: drivers/net/ethernet/emulex/benet/be_main.c:996:6: warning: Value stored to 'head' during its initialization is never read Signed-off-by: Colin Ian King Signed-off-by: David S. Miller

be2net: networking block comments don't use an empty /* line

2018-01-25T21:34:27Z

Resolved Warning: networking block comments don't use an empty /* line, use /* Comment... Issue found by checkpatch. Signed-off-by: Rohit Visavalia Signed-off-by: David S. Miller

Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net

2018-01-23T18:51:56Z

en_rx_am.c was deleted in 'net-next' but had a bug fixed in it in 'net'. The esp{4,6}_offload.c conflicts were overlapping changes. The 'out' label is removed so we just return ERR_PTR(-EINVAL) directly. Signed-off-by: David S. Miller

be2net: restore properly promisc mode after queues reconfiguration

2018-01-22T21:22:42Z

The commit 622190669403 ("be2net: Request RSS capability of Rx interface depending on number of Rx rings") modified be_update_queues() so the IFACE (HW representation of the netdevice) is destroyed and then re-created. This causes a regression because potential promiscuous mode is not restored properly during be_open() because the driver thinks that the HW has promiscuous mode already enabled. Note that Lancer is not affected by this bug because RX-filter flags are disabled during be_close() for this chipset. Cc: Sathya Perla Cc: Ajit Khaparde Cc: Sriharsha Basavapatna Cc: Somnath Kotur Fixes: 622190669403 ("be2net: Request RSS capability of Rx interface depending on number of Rx rings") Signed-off-by: Ivan Vecera Signed-off-by: David S. Miller

be2net: use ARRAY_SIZE for array sizing calculation on array cmd_priv_map

2018-01-09T16:40:18Z

Use the ARRAY_SIZE macro on array cmd_priv_map to determine size of the array. Improvement suggested by coccinelle. Signed-off-by: Colin Ian King Signed-off-by: David S. Miller

locking/atomics: COCCINELLE/treewide: Convert trivial ACCESS_ONCE() patterns to READ_ONCE()/WRITE_ONCE()

2017-10-25T09:01:08Z

Please do not apply this to mainline directly, instead please re-run the coccinelle script shown below and apply its output. For several reasons, it is desirable to use {READ,WRITE}_ONCE() in preference to ACCESS_ONCE(), and new code is expected to use one of the former. So far, there's been no reason to change most existing uses of ACCESS_ONCE(), as these aren't harmful, and changing them results in churn. However, for some features, the read/write distinction is critical to correct operation. To distinguish these cases, separate read/write accessors must be used. This patch migrates (most) remaining ACCESS_ONCE() instances to {READ,WRITE}_ONCE(), using the following coccinelle script: ---- // Convert trivial ACCESS_ONCE() uses to equivalent READ_ONCE() and // WRITE_ONCE() // $ make coccicheck COCCI=/home/mark/once.cocci SPFLAGS="--include-headers" MODE=patch virtual patch @ depends on patch @ expression E1, E2; @@ - ACCESS_ONCE(E1) = E2 + WRITE_ONCE(E1, E2) @ depends on patch @ expression E; @@ - ACCESS_ONCE(E) + READ_ONCE(E) ---- Signed-off-by: Mark Rutland Signed-off-by: Paul E. McKenney Cc: Linus Torvalds Cc: Peter Zijlstra Cc: Thomas Gleixner Cc: davem@davemloft.net Cc: linux-arch@vger.kernel.org Cc: mpe@ellerman.id.au Cc: shuah@kernel.org Cc: snitzer@redhat.com Cc: thor.thayer@linux.intel.com Cc: tj@kernel.org Cc: viro@zeniv.linux.org.uk Cc: will.deacon@arm.com Link: http://lkml.kernel.org/r/1508792849-3115-19-git-send-email-paulmck@linux.vnet.ibm.com Signed-off-by: Ingo Molnar

be2net: fix TSO6/GSO issue causing TX-stall on Lancer/BEx

2017-09-13T16:28:18Z

IPv6 TSO requests with extension hdrs are a problem to the Lancer and BEx chips. Workaround is to disable TSO6 feature for such packets. Also in Lancer chips, MSS less than 256 was resulting in TX stall. Fix this by disabling GSO when MSS less than 256. Signed-off-by: Suresh Reddy Signed-off-by: David S. Miller