kernel/drivers/net/ethernet/broadcom/bgmac.h, branch linux-6.18.y

bgmac: reduce max frame size to support just MTU 1500

2025-01-30T02:57:42Z

bgmac allocates new replacement buffer before handling each received frame. Allocating & DMA-preparing 9724 B each time consumes a lot of CPU time. Ideally bgmac should just respect currently set MTU but it isn't the case right now. For now just revert back to the old limited frame size. This change bumps NAT masquerade speed by ~95%. Since commit 8218f62c9c9b ("mm: page_frag: use initial zero offset for page_frag_alloc_align()"), the bgmac driver fails to open its network interface successfully and runs out of memory in the following call stack: bgmac_open -> bgmac_dma_init -> bgmac_dma_rx_skb_for_slot -> netdev_alloc_frag BGMAC_RX_ALLOC_SIZE = 10048 and PAGE_FRAG_CACHE_MAX_SIZE = 32768. Eventually we land into __page_frag_alloc_align() with the following parameters across multiple successive calls: __page_frag_alloc_align: fragsz=10048, align_mask=-1, size=32768, offset=0 __page_frag_alloc_align: fragsz=10048, align_mask=-1, size=32768, offset=10048 __page_frag_alloc_align: fragsz=10048, align_mask=-1, size=32768, offset=20096 __page_frag_alloc_align: fragsz=10048, align_mask=-1, size=32768, offset=30144 So in that case we do indeed have offset + fragsz (40192) > size (32768) and so we would eventually return NULL. Reverting to the older 1500 bytes MTU allows the network driver to be usable again. Fixes: 8c7da63978f1 ("bgmac: configure MTU and add support for frames beyond 8192 byte size") Signed-off-by: Rafał Miłecki [florian: expand commit message about recent commits] Reviewed-by: Simon Horman Signed-off-by: Florian Fainelli Link: https://patch.msgid.link/20250127175159.1788246-1-florian.fainelli@broadcom.com Signed-off-by: Jakub Kicinski

bgmac: fix initial chip reset to support BCM5358

2023-02-28T10:10:05Z

While bringing hardware up we should perform a full reset including the switch bit (BGMAC_BCMA_IOCTL_SW_RESET aka SICF_SWRST). It's what specification says and what reference driver does. This seems to be critical for the BCM5358. Without this hardware doesn't get initialized properly and doesn't seem to transmit or receive any packets. Originally bgmac was calling bgmac_chip_reset() before setting "has_robosw" property which resulted in expected behaviour. That has changed as a side effect of adding platform device support which regressed BCM5358 support. Fixes: f6a95a24957a ("net: ethernet: bgmac: Add platform device support") Cc: Jon Mason Signed-off-by: Rafał Miłecki Reviewed-by: Leon Romanovsky Reviewed-by: Florian Fainelli Link: https://lore.kernel.org/r/20230227091156.19509-1-zajec5@gmail.com Signed-off-by: Paolo Abeni

net: bgmac: remove a copy of the NAPI_POLL_WEIGHT define

2022-04-29T10:56:41Z

Defining local versions of NAPI_POLL_WEIGHT with the same values in the drivers just makes refactoring harder. Reviewed-by: Florian Fainelli Signed-off-by: Jakub Kicinski Signed-off-by: David S. Miller

net: broadcom: share header defining UniMAC registers

2021-01-09T03:17:28Z

UniMAC is integrated into multiple Broadcom's Ethernet controllers so use a shared header file for it and avoid some code duplication. Signed-off-by: Rafał Miłecki Acked-by: Florian Fainelli Acked-by: Doug Berger Link: https://lore.kernel.org/r/20210107180051.1542-2-zajec5@gmail.com Signed-off-by: Jakub Kicinski

bgmac: add bgmac_umac_*() helpers for accessing UniMAC registers

2021-01-09T03:17:28Z

UniMAC is a hardware block commonly used in Broadcom Ethernet controllers that should get its own header file. Not every controller has it mapped at the 0x800 offset so add bgmac access helpers. They will allow using shared register defines. Signed-off-by: Rafał Miłecki Acked-by: Florian Fainelli Link: https://lore.kernel.org/r/20210107180051.1542-1-zajec5@gmail.com Signed-off-by: Jakub Kicinski

bgmac: configure MTU and add support for frames beyond 8192 byte size

2020-03-27T23:07:24Z

Change DMA descriptor length to handle jumbo frames beyond 8192 bytes. Also update jumbo frame max size to include FCS, the DMA packet length received includes FCS. Signed-off-by: Murali Krishna Policharla Reviewed-by: Arun Parameswaran Reviewed-by: Ray Jui Signed-off-by: Vladimir Oltean Signed-off-by: David S. Miller

net: bgmac: Correctly annotate register space

2018-04-02T02:20:48Z

All the members: base, idm_base and nicpm_base should be annotated with __iomem since they are pointers to register space. This fixes a bunch of sparse reported warnings. Fixes: f6a95a24957a ("net: ethernet: bgmac: Add platform device support") Fixes: dd5c5d037f5e ("net: ethernet: bgmac: add NS2 support") Signed-off-by: Florian Fainelli Signed-off-by: David S. Miller

License cleanup: add SPDX GPL-2.0 license identifier to files with no license

2017-11-02T10:10:55Z

Many source files in the tree are missing licensing information, which makes it harder for compliance tools to determine the correct license. By default all files without license information are under the default license of the kernel, which is GPL version 2. Update the files which contain no license information with the 'GPL-2.0' SPDX license identifier. The SPDX identifier is a legally binding shorthand, which can be used instead of the full boiler plate text. This patch is based on work done by Thomas Gleixner and Kate Stewart and Philippe Ombredanne. How this work was done: Patches were generated and checked against linux-4.14-rc6 for a subset of the use cases: - file had no licensing information it it. - file was a */uapi/* one with no licensing information in it, - file was a */uapi/* one with existing licensing information, Further patches will be generated in subsequent months to fix up cases where non-standard license headers were used, and references to license had to be inferred by heuristics based on keywords. The analysis to determine which SPDX License Identifier to be applied to a file was done in a spreadsheet of side by side results from of the output of two independent scanners (ScanCode & Windriver) producing SPDX tag:value files created by Philippe Ombredanne. Philippe prepared the base worksheet, and did an initial spot review of a few 1000 files. The 4.13 kernel was the starting point of the analysis with 60,537 files assessed. Kate Stewart did a file by file comparison of the scanner results in the spreadsheet to determine which SPDX license identifier(s) to be applied to the file. She confirmed any determination that was not immediately clear with lawyers working with the Linux Foundation. Criteria used to select files for SPDX license identifier tagging was: - Files considered eligible had to be source code files. - Make and config files were included as candidates if they contained >5 lines of source - File already had some variant of a license header in it (even if <5 lines). All documentation files were explicitly excluded. The following heuristics were used to determine which SPDX license identifiers to apply. - when both scanners couldn't find any license traces, file was considered to have no license information in it, and the top level COPYING file license applied. For non */uapi/* files that summary was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 11139 and resulted in the first patch in this series. If that file was a */uapi/* path one, it was "GPL-2.0 WITH Linux-syscall-note" otherwise it was "GPL-2.0". Results of that was: SPDX license identifier # files ---------------------------------------------------|------- GPL-2.0 WITH Linux-syscall-note 930 and resulted in the second patch in this series. - if a file had some form of licensing information in it, and was one of the */uapi/* ones, it was denoted with the Linux-syscall-note if any GPL family license was found in the file or had no licensing in it (per prior point). Results summary: SPDX license identifier # files ---------------------------------------------------|------ GPL-2.0 WITH Linux-syscall-note 270 GPL-2.0+ WITH Linux-syscall-note 169 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-2-Clause) 21 ((GPL-2.0 WITH Linux-syscall-note) OR BSD-3-Clause) 17 LGPL-2.1+ WITH Linux-syscall-note 15 GPL-1.0+ WITH Linux-syscall-note 14 ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause) 5 LGPL-2.0+ WITH Linux-syscall-note 4 LGPL-2.1 WITH Linux-syscall-note 3 ((GPL-2.0 WITH Linux-syscall-note) OR MIT) 3 ((GPL-2.0 WITH Linux-syscall-note) AND MIT) 1 and that resulted in the third patch in this series. - when the two scanners agreed on the detected license(s), that became the concluded license(s). - when there was disagreement between the two scanners (one detected a license but the other didn't, or they both detected different licenses) a manual inspection of the file occurred. - In most cases a manual inspection of the information in the file resulted in a clear resolution of the license that should apply (and which scanner probably needed to revisit its heuristics). - When it was not immediately clear, the license identifier was confirmed with lawyers working with the Linux Foundation. - If there was any question as to the appropriate license identifier, the file was flagged for further research and to be revisited later in time. In total, over 70 hours of logged manual review was done on the spreadsheet to determine the SPDX license identifiers to apply to the source files by Kate, Philippe, Thomas and, in some cases, confirmation by lawyers working with the Linux Foundation. Kate also obtained a third independent scan of the 4.13 code base from FOSSology, and compared selected files where the other two scanners disagreed against that SPDX file, to see if there was new insights. The Windriver scanner is based on an older version of FOSSology in part, so they are related. Thomas did random spot checks in about 500 files from the spreadsheets for the uapi headers and agreed with SPDX license identifier in the files he inspected. For the non-uapi files Thomas did random spot checks in about 15000 files. In initial set of patches against 4.14-rc6, 3 files were found to have copy/paste license identifier errors, and have been fixed to reflect the correct identifier. Additionally Philippe spent 10 hours this week doing a detailed manual inspection and review of the 12,461 patched files from the initial patch version early this week with: - a full scancode scan run, collecting the matched texts, detected license ids and scores - reviewing anything where there was a license detected (about 500+ files) to ensure that the applied SPDX license was correct - reviewing anything where there was no detection but the patch license was not GPL-2.0 WITH Linux-syscall-note to ensure that the applied SPDX license was correct This produced a worksheet with 20 files needing minor correction. This worksheet was then exported into 3 different .csv files for the different types of files to be modified. These .csv files were then reviewed by Greg. Thomas wrote a script to parse the csv files and add the proper SPDX tag to the file, in the format that the file expected. This script was further refined by Greg based on the output to detect more types of files automatically and to distinguish between header and source .c files (which need different comment types.) Finally Greg ran the script using the .csv files to generate the patches. Reviewed-by: Kate Stewart Reviewed-by: Philippe Ombredanne Reviewed-by: Thomas Gleixner Signed-off-by: Greg Kroah-Hartman

net: ethernet: bgmac: Make IDM register space optional

2017-07-15T21:28:27Z

IDM operations are usually one time ops and should be done in firmware itself. Driver is not supposed to touch IDM registers. However, for some SoCs', driver is performing IDM read/writes. So this patch masks IDM operations in case firmware is taking care of IDM operations. Signed-off-by: Abhishek Shah Reviewed-by: Oza Oza Reviewed-by: Ray Jui Reviewed-by: Scott Branden Signed-off-by: David S. Miller

net: ethernet: bgmac: driver power manangement

2017-03-07T01:17:47Z

Implement suspend/resume callbacks in the bgmac driver. This makes sure that we de-initialize and re-initialize the hardware correctly before entering suspend and when resuming. Signed-off-by: Joey Zhong Signed-off-by: Jon Mason Reviewed-by: Florian Fainelli Signed-off-by: David S. Miller