kernel/drivers/memory, branch linux-5.17.y

memory: samsung: exynos5422-dmc: Avoid some over memory allocation

2022-06-09T08:25:59Z

[ Upstream commit 56653827f0d7bc7c2d8bac0e119fd1521fa9990a ] 'dmc->counter' is a 'struct devfreq_event_dev **', so there is some over memory allocation. 'counters_size' should be computed with 'sizeof(struct devfreq_event_dev *)'. Use 'sizeof(*dmc->counter)' instead to fix it. While at it, use devm_kcalloc() instead of devm_kzalloc()+open coded multiplication. Fixes: 6e7674c3c6df ("memory: Add DMC driver for Exynos5422") Signed-off-by: Christophe JAILLET Link: https://lore.kernel.org/r/69d7e69346986e2fdb994d4382954c932f9f0993.1647760213.git.christophe.jaillet@wanadoo.fr Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

memory: renesas-rpc-if: Fix HF/OSPI data transfer in Manual Mode

2022-05-09T07:16:21Z

[ Upstream commit 7e842d70fe599bc13594b650b2144c4b6e6d6bf1 ] HyperFlash devices fail to probe: rpc-if-hyperflash rpc-if-hyperflash: probing of hyperbus device failed In HyperFlash or Octal-SPI Flash mode, the Transfer Data Enable bits (SPIDE) in the Manual Mode Enable Setting Register (SMENR) are derived from half of the transfer size, cfr. the rpcif_bits_set() helper function. However, rpcif_reg_{read,write}() does not take the bus size into account, and does not double all Manual Mode Data Register access sizes when communicating with a HyperFlash or Octal-SPI Flash device. Fix this, and avoid the back-and-forth conversion between transfer size and Transfer Data Enable bits, by explicitly storing the transfer size in struct rpcif, and using that value to determine access size in rpcif_reg_{read,write}(). Enforce that the "high" Manual Mode Read/Write Data Registers (SM[RW]DR1) are only used for 8-byte data accesses. While at it, forbid writing to the Manual Mode Read Data Registers, as they are read-only. Fixes: fff53a551db50f5e ("memory: renesas-rpc-if: Correct QSPI data transfer in Manual mode") Signed-off-by: Geert Uytterhoeven Signed-off-by: Krzysztof Kozlowski Tested-by: Lad Prabhakar Tested-by: Wolfram Sang Reviewed-by: Wolfram Sang Link: https://lore.kernel.org/r/cde9bfacf704c81865f57b15d1b48a4793da4286.1649681476.git.geert+renesas@glider.be Link: https://lore.kernel.org/r/20220420070526.9367-1-krzysztof.kozlowski@linaro.org' Signed-off-by: Arnd Bergmann Signed-off-by: Sasha Levin

memory: renesas-rpc-if: fix platform-device leak in error path

2022-04-20T07:36:24Z

commit b452dbf24d7d9a990d70118462925f6ee287d135 upstream. Make sure to free the flash platform device in the event that registration fails during probe. Fixes: ca7d8b980b67 ("memory: add Renesas RPC-IF driver") Cc: stable@vger.kernel.org # 5.8 Cc: Sergei Shtylyov Signed-off-by: Johan Hovold Link: https://lore.kernel.org/r/20220303180632.3194-1-johan@kernel.org Signed-off-by: Krzysztof Kozlowski Signed-off-by: Greg Kroah-Hartman

memory: atmel-ebi: Fix missing of_node_put in atmel_ebi_probe

2022-04-20T07:36:11Z

[ Upstream commit 6f296a9665ba5ac68937bf11f96214eb9de81baa ] The device_node pointer is returned by of_parse_phandle() with refcount incremented. We should use of_node_put() on it when done. Fixes: 87108dc78eb8 ("memory: atmel-ebi: Enable the SMC clock if specified") Signed-off-by: Miaoqian Lin Reviewed-by: Claudiu Beznea Link: https://lore.kernel.org/r/20220309110144.22412-1-linmq006@gmail.com Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

memory: emif: check the pointer temp in get_device_details()

2022-04-08T11:57:50Z

[ Upstream commit 5b5ab1bfa1898c6d52936a57c25c5ceba2cb2f87 ] The pointer temp is allocated by devm_kzalloc(), so it should be checked for error handling. Fixes: 7ec944538dde ("memory: emif: add basic infrastructure for EMIF driver") Signed-off-by: Jia-Ju Bai Link: https://lore.kernel.org/r/20220225132552.27894-1-baijiaju1990@gmail.com Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

memory: emif: Add check for setup_interrupts

2022-04-08T11:57:50Z

[ Upstream commit fd7bd80b46373887b390852f490f21b07e209498 ] As the potential failure of the devm_request_threaded_irq(), it should be better to check the return value of the setup_interrupts() and return error if fails. Fixes: 68b4aee35d1f ("memory: emif: add interrupt and temperature handling") Signed-off-by: Jiasheng Jiang Link: https://lore.kernel.org/r/20220224025444.3256530-1-jiasheng@iscas.ac.cn Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

memory: tegra20-emc: Correct memory device mask

2022-04-08T11:57:43Z

[ Upstream commit 9ff684342ee7d3ea2755c6e9b60bc43085baa3ad ] Memory chip select is swapped when we read mode register, correct it. We didn't have devices that use a single LPDDR chip and both chips are always identical, hence this change is just a minor improvement. Fixes: 131dd9a436d8 ("memory: tegra20-emc: Support matching timings by LPDDR2 configuration") Signed-off-by: Dmitry Osipenko Link: https://lore.kernel.org/r/20211222043215.28237-2-digetx@gmail.com Signed-off-by: Krzysztof Kozlowski Signed-off-by: Sasha Levin

Merge tag 'mtd/for-5.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux

2022-01-11T19:35:28Z

Pull MTD updates from Miquel Raynal: "MTD core changes: - mtdchar: Prevent unbounded allocation in MEMWRITE ioctl - gen_probe: Use bitmap_zalloc() when applicable - Introduce an expert mode for forensics and debugging purposes - Clear out unregistered devices a bit more - Provide unique name for nvmem device - Remove unused header file - Fixed breaking list in __mtd_del_partition. MTD device changes: - Warn about failure to unregister mtd device in sst25l, mchp48l640, mchp23k256, and dataflash drivers. Raw NAND core changes: - Export nand_read_page_hwecc_oob_first() GPMC memory controller for OMAP2 NAND controller changes: - Add support for AM64 SoC and allow build on K3 platforms - Use a compatible match table when checking for NAND controller - Use platform_get_irq() to get the interrupt Raw NAND controller changes: - OMAP2 NAND controller: - Document the missing 'rb-gpios' DT property - Drop unused variable - Fix force_8bit flag behaviour for DMA mode - Move to exec_op interface - Use platform_get_irq() to get the interrupt - Renesas: - Add new NAND controller driver with its bindings and MAINTAINERS entry - Onenand: - Remove redundant variable ooblen - MPC5121: - Remove unused variable in ads5121_select_chip() - GPMI: - Add ERR007117 protection for nfc_apply_timings - Remove explicit default gpmi clock setting for i.MX6 - Use platform_get_irq_byname() to get the interrupt - Remove unneeded variable - Ingenic: - JZ4740 needs 'oob_first' read page function - Davinci: - Rewrite function description - Avoid duplicated page read - Don't calculate ECC when reading page SPI NOR core changes: - Add Pratyush as SPI NOR co-maintainer. - Flash parameters initialization was done in a spaghetti way. Clean flash parameters initialization. - Rework the flash_info flags and clarify where one should be used. - Initialize all flash parameters based on JESD216 SFDP where possible. Flash parameters and settings that are SFDP discoverable should not be duplicated via flash_info flags at flash declaration. - Remove debugfs entries that duplicate sysfs entries. SPI NOR manufacturer driver changes: - Use late_init() hook in various drivers to make it clear that those flash parameters are either not declared in the JESD216 SFDP standard, or the SFDP tables which define those flash parameters are not defined by the flash. - Fix mtd size for s3an flashes. - Write 2 bytes when disabling Octal DTR mode: 1 byte long transactions are not allowed in 8D-8D-8D mode. Hyperbus changes: - Couple of fixes in Renesas hyperbus rpc-if driver to avoid crash on module remove and for missing check for error value in probe" * tag 'mtd/for-5.17' of git://git.kernel.org/pub/scm/linux/kernel/git/mtd/linux: (71 commits) mtd: spi-nor: Remove debugfs entries that duplicate sysfs entries mtd: spi-nor: micron-st: write 2 bytes when disabling Octal DTR mode mtd: spi-nor: spansion: write 2 bytes when disabling Octal DTR mode mtd: spi-nor: core: use 2 data bytes for template ops mtd: spi-nor: Constify part specific fixup hooks mtd: spi-nor: core: Remove reference to spi-nor.c mtd: rawnand: gpmi: Use platform_get_irq_byname() to get the interrupt mtd: rawnand: omap_elm: Use platform_get_irq() to get the interrupt mtd: rawnand: omap2: Select GPMC device driver for ARCH_K3 memory: omap-gpmc: Use a compatible match table when checking for NAND controller memory: omap-gpmc: Add support for GPMC on AM64 SoC dt-bindings: memory-controllers: ti,gpmc: Add compatible for AM64 memory: omap-gpmc: Use platform_get_irq() to get the interrupt MAINTAINERS: Add an entry for Renesas NAND controller mtd: rawnand: renesas: Add new NAND controller driver dt-bindings: mtd: renesas: Describe Renesas R-Car Gen3 & RZ/N1 NAND controller mtd: rawnand: gpmi: remove unneeded variable mtd: rawnand: omap2: drop unused variable mtd: rawnand: omap2: fix force_8bit flag behaviour for DMA mode mtd: rawnand: omap2: Add compatible for AM64 SoC ...

Merge tag 'drivers-5.17' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

2022-01-10T16:13:52Z

Pull ARM SoC driver updates from Arnd Bergmann: "There are cleanups and minor bugfixes across several SoC specific drivers, for Qualcomm, Samsung, NXP i.MX, AT91, Tegra, Keystone, Renesas, ZynqMP Noteworthy new features are: - The op-tee firmware driver gains support for asynchronous notifications from secure-world firmware. - Qualcomm platforms gain support for new SoC types in various drivers: power domain, cache controller, RPM sleep, soc-info - Samsung SoC drivers gain support for new SoCs in ChipID and PMU, as well as a new USIv2 driver that handles various types of serial communiction (uart, i2c, spi) - Renesas adds support for R-Car S4-8 (R8A779F0) in multiple drivers, as well as memory controller support for RZ/G2L (R9A07G044). - Apple M1 gains support for the PMGR power management driver" * tag 'drivers-5.17' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (94 commits) soc: qcom: rpmh-rsc: Fix typo in a comment soc: qcom: socinfo: Add SM6350 and SM7225 dt-bindings: arm: msm: Don't mark LLCC interrupt as required dt-bindings: firmware: scm: Add SM6350 compatible dt-bindings: arm: msm: Add LLCC for SM6350 soc: qcom: rpmhpd: Sort power-domain definitions and lists soc: qcom: rpmhpd: Remove mx/cx relationship on sc7280 soc: qcom: rpmhpd: Rename rpmhpd struct names soc: qcom: rpmhpd: sm8450: Add the missing .peer for sm8450_cx_ao soc: qcom: socinfo: add SM8450 ID soc: qcom: rpmhpd: Add SM8450 power domains dt-bindings: power: rpmpd: Add SM8450 to rpmpd binding soc: qcom: smem: Update max processor count dt-bindings: arm: qcom: Document SM8450 SoC and boards dt-bindings: firmware: scm: Add SM8450 compatible dt-bindings: arm: cpus: Add kryo780 compatible soc: qcom: rpmpd: Add support for sm6125 dt-bindings: qcom-rpmpd: Add sm6125 power domains soc: qcom: aoss: constify static struct thermal_cooling_device_ops PM: AVS: qcom-cpr: Use div64_ul instead of do_div ...

memory: omap-gpmc: Use a compatible match table when checking for NAND controller

2021-12-22T15:51:14Z

As more compatibles can be added to the GPMC NAND controller driver use a compatible match table. Signed-off-by: Roger Quadros Acked-by: Miquel Raynal Link: https://lore.kernel.org/r/20211221131757.2030-4-rogerq@kernel.org [krzysztof: remove "is_nand" variable] Signed-off-by: Krzysztof Kozlowski