kernel/drivers/gpu/drm/rockchip/cdn-dp-core.c, branch linux-4.17.y

drm/rockchip: cdn-dp: remove the DP phy switch

2018-03-16T10:51:11Z

There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence only one PHY can connect to DP controller at one time, the other should be disconnected. The GRF_SOC_CON26 register has a switch bit to do it, set this bit means enable PHY 1, clear this bit means enable PHY 0. If the board has 2 Type-C ports, the DP driver get the phy id from devm_of_phy_get_by_index, and then control this switch according to this id. But some others board only has one Type-C port, it may be PHY 0 or PHY 1. The dts node id can not tell us the correct PHY id. Hence move this switch to PHY driver, the PHY driver can distinguish between PHY 0 and PHY 1, and then write the correct register bit. Signed-off-by: Chris Zhong Signed-off-by: Enric Balletbo i Serra [The phy-changes are in the phy-tree now and the cdn-dp wasn't enabled at all so far, so this change can go through drm-misc alone without causing issues when testing drm-misc] Signed-off-by: Heiko Stuebner Link: https://patchwork.freedesktop.org/patch/msgid/20180216120956.19034-6-enric.balletbo@collabora.com

drm/drivers: drop redundant drm_edid_to_eld() calls

2017-11-07T15:43:35Z

drm_add_edid_modes() now fills in the ELD automatically, so the calls to drm_edid_to_eld() are redundant. Remove them. All the other places are obvious, but nv50 has detached drm_edid_to_eld() from the drm_add_edid_modes() call. Cc: Alex Deucher Cc: Christian König Cc: Archit Taneja Cc: Andrzej Hajda Cc: Russell King Cc: CK Hu Cc: Philipp Zabel Cc: Ben Skeggs Cc: Mark Yao Cc: Benjamin Gaignard Cc: Vincent Abriou Cc: Thierry Reding Cc: Eric Anholt Acked-by: Eric Anholt Acked-by: Archit Taneja Reviewed-by: Ville Syrjälä Reviewed-by: Alex Deucher Acked-by: Thierry Reding Signed-off-by: Jani Nikula Link: https://patchwork.freedesktop.org/patch/msgid/0959ca02b983afc9e74dd9acd190ba6e25f21678.1509545641.git.jani.nikula@intel.com

drm/rockchip: Rely on the default best_encoder() behavior

2017-09-27T20:01:56Z

Since the output has 1:1 relationship between connectors and encoders, and the driver is relying on the atomic helpers, remove the custom best_encoder() and let the core call drm_atomic_helper_best_encoder(). Signed-off-by: Haneen Mohammed Signed-off-by: Sean Paul Link: https://patchwork.freedesktop.org/patch/msgid/20170927182317.GA8249@Haneen

drm: Nuke drm_atomic_helper_connector_dpms

2017-08-08T12:48:48Z

It's dead code, the core handles all this directly now. The only special case is nouveau and tda988x which used one function for both legacy modeset code and -nv50 atomic world instead of 2 vtables. But amounts to exactly the same. v2: Rebase over the panel/brideg refactorings in stm/ltdc. Signed-off-by: Daniel Vetter Cc: Archit Taneja Cc: Andrzej Hajda Cc: Laurent Pinchart Cc: Peter Senna Tschudin Cc: Martin Donnelly Cc: Martyn Welch Cc: Daniel Vetter Cc: Jani Nikula Cc: Sean Paul Cc: David Airlie Cc: Inki Dae Cc: Joonyoung Shim Cc: Seung-Woo Kim Cc: Kyungmin Park Cc: Kukjin Kim Cc: Krzysztof Kozlowski Cc: Stefan Agner Cc: Alison Wang Cc: Russell King Cc: Philipp Zabel Cc: CK Hu Cc: Matthias Brugger Cc: Neil Armstrong Cc: Carlo Caione Cc: Kevin Hilman Cc: Marek Vasut Cc: Ben Skeggs Cc: Tomi Valkeinen Cc: Eric Anholt Cc: Mark Yao Cc: Heiko Stuebner Cc: Benjamin Gaignard Cc: Vincent Abriou Cc: Yannick Fertre Cc: Philippe Cornu Cc: Maxime Ripard Cc: Chen-Yu Tsai Cc: Thierry Reding Cc: Jonathan Hunter Cc: Jyri Sarha Cc: Gerd Hoffmann Cc: Shawn Guo Cc: John Stultz Cc: Lars-Peter Clausen Cc: Sergei Shtylyov Cc: Jeffy Chen Cc: Tomeu Vizoso Cc: Yakir Yang Cc: Marek Szyprowski Cc: Jose Abreu Cc: Romain Perier Cc: Kieran Bingham Cc: Xinliang Liu Cc: Alexey Brodkin Cc: Alex Deucher Cc: Rongrong Zou Cc: Rob Clark Cc: Hai Li Cc: "Noralf Trønnes" Cc: linux-arm-kernel@lists.infradead.org Cc: linux-samsung-soc@vger.kernel.org Cc: intel-gfx@lists.freedesktop.org Cc: linux-mediatek@lists.infradead.org Cc: linux-amlogic@lists.infradead.org Cc: nouveau@lists.freedesktop.org Cc: linux-renesas-soc@vger.kernel.org Cc: linux-rockchip@lists.infradead.org Cc: linux-tegra@vger.kernel.org Cc: virtualization@lists.linux-foundation.org Cc: zain wang Cc: Baoyou Xie Cc: Boris Brezillon Reviewed-by: Maarten Lankhorst Link: https://patchwork.freedesktop.org/patch/msgid/20170725080122.20548-8-daniel.vetter@ffwll.ch Acked-by: Neil Armstrong Reviewed-by: Neil Armstrong Acked-by: Philipp Zabel Acked-by: Archit Taneja Tested-by: Philippe Cornu (on stm) Reviewed-by: Laurent Pinchart Acked-by: Shawn Guo Acked-by: Shawn Guo Acked-by: Noralf Trønnes Acked-by: Vincent Abriou

drm/rockchip: fix NULL check on devm_kzalloc() return value

2017-07-10T18:13:00Z

The right variable to check here is port, not dp. This issue was detected using Coccinelle and the following semantic patch: @@ expression x; identifier fld; @@ * x = devm_kzalloc(...); ... when != x == NULL x->fld Signed-off-by: Gustavo A. R. Silva Acked-by: Mark Yao Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/20170706215833.GA25411@embeddedgus

drm/rockchip: Correct vop out_mode configure

2017-05-31T03:13:34Z

Force vop output mode on encoder driver seem not a good idea, EDP, HDMI, DisplayPort all have 10bit input on rk3399, On non-10bit vop, vop 8bit output bit[0-7] connect to the encoder high 8bit [2-9]. So force RGB10 to RGB888 on vop driver would be better. And another problem, EDP check crtc id on atomic_check, but encoder maybe NULL, so out_mode configure would fail, it cause edp no display. Signed-off-by: Mark Yao Reviewed-by: Jeffy Chen Link: http://patchwork.freedesktop.org/patch/msgid/1495885416-22216-1-git-send-email-mark.yao@rock-chips.com

drm/rockchip: cdn-dp: Don't unregister audio dev when unbinding

2017-04-07T17:28:32Z

After snd_soc_unregister_codec, the dai link would remain bound to the invalid codec. That would cause crashes after unbind dp driver. Let's unregister audio codec when removing dp driver to prevent that. Signed-off-by: Jeffy Chen Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/1491481885-13775-7-git-send-email-jeffy.chen@rock-chips.com

drm/rockchip: cdn-dp: Don't try to release firmware when not loaded

2017-04-07T17:28:32Z

Signed-off-by: Jeffy Chen Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/1491481885-13775-6-git-send-email-jeffy.chen@rock-chips.com

drm/rockchip: Refactor the component match logic.

2017-03-24T18:48:58Z

Currently we are adding all components from the dts, if one of their drivers been disabled, we would not be able to bring up others. Refactor component match logic, follow exynos drm. Signed-off-by: Jeffy Chen Reviewed-by: Andrzej Hajda Acked-by: Mark Yao Tested-by: Heiko Stuebner Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/1490152880-21855-1-git-send-email-jeffy.chen@rock-chips.com

Merge tag 'doc-4.11-images' of git://git.lwn.net/linux into drm-misc-next

2017-03-14T14:07:33Z

Pointer for Markus's image conversion work. We need this so we can merge all the pretty drm graphs for 4.12. Signed-off-by: Daniel Vetter