kernel/drivers/gpu/drm/panel/Makefile, branch linux-4.1.y

drm/panel: Add Sharp LQ101R1SX01 support

2014-11-13T12:56:19Z

This panel requires dual-channel mode. The device accepts command-mode data on 8 lanes and will therefore need a dual-channel DSI controller. The two interfaces that make up this device need to be instantiated in the controllers that gang up to provide the dual-channel DSI host. Reviewed-by: Sean Paul Signed-off-by: Thierry Reding

drm/panel: add S6E8AA0 driver

2014-04-04T12:24:49Z

The patch adds MIPI-DSI based S6E8AA0 AMOLED LCD panel driver. Driver uses mipi_dsi bus to communicate with panel and exposes drm_panel interface. v2 - added bus error handling, - set maxmimum DSI packet size on init, - removed unsupported brightness drm_panel callbacks, - minor improvements v3 - switched to gpiod framework, - minor fixes in error handling Signed-off-by: Andrzej Hajda Signed-off-by: Inki Dae

drm/panel: add ld9040 driver

2014-04-04T12:24:48Z

The patch adds LD9040 parallel RGB panel driver with SPI control interface. The driver uses drm_panel framework. Signed-off-by: Andrzej Hajda Signed-off-by: Inki Dae

drm/panel: Add simple panel support

2013-12-17T17:09:51Z

Add a driver for simple panels. Such panels can have a regulator that provides the supply voltage and a separate GPIO to enable the panel. Optionally the panels can have a backlight associated with them so it can be enabled or disabled according to the panel's power management mode. Support is added for two panels: An AU Optronics 10.1" WSVGA and a Chunghwa Picture Tubes 10.1" WXGA panel. Signed-off-by: Thierry Reding