kernel/arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi, branch linux-5.3.y

arm64: dts: allwinner: a64: Re-add PMU node

2019-12-17T19:08:40Z

[ Upstream commit 6b832a148717f1718f57805a9a4aa7f092582d15 ] As it was found recently, the Performance Monitoring Unit (PMU) on the Allwinner A64 SoC was not generating (the right) interrupts. With the SPI numbers from the manual the kernel did not receive any overflow interrupts, so perf was not happy at all. It turns out that the numbers were just off by 4, so the PMU interrupts are from 148 to 151, not from 152 to 155 as the manual describes. This was found by playing around with U-Boot, which typically does not use interrupts, so the GIC is fully available for experimentation: With *every* PPI and SPI enabled, an overflowing PMU cycle counter was found to set a bit in one of the GICD_ISPENDR registers, with careful counting this was determined to be number 148. Tested with perf record and perf top on a Pine64-LTS. Also tested with tasksetting to every core to confirm the assignment between IRQs and cores. This somewhat "revert-fixes" commit ed3e9406bcbc ("arm64: dts: allwinner: a64: Drop PMU node"). Fixes: 34a97fcc71c2 ("arm64: dts: allwinner: a64: Add PMU node") Fixes: ed3e9406bcbc ("arm64: dts: allwinner: a64: Drop PMU node") Signed-off-by: Andre Przywara Signed-off-by: Maxime Ripard Signed-off-by: Sasha Levin

arm64: dts: allwinner: a64: Drop PMU node

2019-11-10T10:33:49Z

[ Upstream commit ed3e9406bcbc32f84dc4aa4cb4767852e5ab086c ] Looks like PMU in A64 is broken, it generates no interrupts at all and as result 'perf top' shows no events. Tested on Pine64-LTS. Fixes: 34a97fcc71c2 ("arm64: dts: allwinner: a64: Add PMU node") Cc: Harald Geyer Cc: Jared D. McNeill Signed-off-by: Vasily Khoruzhick Reviewed-by: Emmanuel Vadot Signed-off-by: Maxime Ripard Signed-off-by: Sasha Levin

arm64: dts: allwinner: a64: Add lradc node

2019-06-05T11:51:29Z

Add a node describing the KEYADC on the A64. Signed-off-by: Luca Weiss Signed-off-by: Maxime Ripard

arm64: dts: allwinner: a64: Add pinmux for RGB666 LCD

2019-05-20T07:40:10Z

Allwinner A64's TCON0 can output RGB666 LCD signal. Add its pinmux. Signed-off-by: Icenowy Zheng Signed-off-by: Vasily Khoruzhick Signed-off-by: Torsten Duwe Signed-off-by: Maxime Ripard

arm64: dts: allwinner: a64: move I2C pinctrl to dtsi

2019-05-20T07:28:01Z

There is only one pinmuxing available for each I2C controller. So, move pinctrl for i2c0, i2c1 from board dts files into SoC dtsi. By moving these pinctrls the i2c1 node from Nanopi A64 just have a status, which is disabled already so remove the entire node from it. Signed-off-by: Jagan Teki Signed-off-by: Maxime Ripard

arm64: dts: allwinner: a64: Add pinmux setting for CSI MCLK on PE1

2019-04-18T14:53:23Z

Some camera modules have the SoC feeding a master clock to the sensor instead of having a standalone crystal. This clock signal is generated from the clock control unit and output from the CSI MCLK function of pin PE1. Add a pinmux setting for it for camera sensors to reference. Signed-off-by: Jagan Teki Signed-off-by: Maxime Ripard

arm64: dts: allwinner: Fix DE2 bus node name

2019-04-17T14:56:59Z

According to the device tree specification, any bus should have a 'bus' node name. Since it isn't the case for us on the DE2 bus, fix that. Signed-off-by: Maxime Ripard

arm64: dts: allwinner: Remove useless phy-names from EHCI and OHCI

2019-04-17T07:58:14Z

Neither the OHCI or EHCI bindings are using the phy-names property, so we can just drop it. Acked-by: Chen-Yu Tsai Signed-off-by: Maxime Ripard

arm64: dts: allwinner: a64: Fix the Codec I2S binding

2019-03-26T19:00:46Z

The I2S binding never mentions a reset-names property, or mentions which value it should have. To avoid any further issue, remove it. Acked-by: Chen-Yu Tsai Signed-off-by: Maxime Ripard

arm64: dts: allwinner: a64: Add default dr_mode

2019-03-26T18:57:53Z

The USB OTG binding we have mandates to have a dr_mode property, yet not all boards are setting it. Since the generic otg binding states that the default mode should be the OTG mode, let's use that one in our DTSI. Acked-by: Chen-Yu Tsai Signed-off-by: Maxime Ripard