kernel/arch/arm/mach-tegra/pm.c, branch linux-6.2.y

soc/tegra: pmc: Prevent racing with cpuilde driver

2021-08-11T09:51:39Z

Both PMC and cpuidle drivers are probed at the same init level and cpuidle depends on the PMC suspend mode. Add new default suspend mode that indicates whether PMC driver has been probed and reset the mode in a case of deferred probe of the PMC driver. Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Do not fully reinitialize L2 on resume

2020-05-06T16:29:05Z

ASUS TF300T device may not work properly if firmware is asked to fully re-initialize L2 cache after resume from LP2 suspend. The downstream kernel of TF300T uses different opcode to enable cache after resuming from LP2, this opcode also works fine on Nexus 7 and Ouya devices. Supposedly, this may be needed by an older firmware versions. Reported-by: Michał Mirosław Tested-by: Michał Mirosław Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Peter Geis Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Make outer_disable() open-coded

2020-03-13T10:23:08Z

The outer_disable() of Tegra's suspend code is open-coded now since that helper produces spurious warning message about secondary CPUs being online when CPU enters into LP2 from cpuidle. The secondaries are actually halted by the cpuidle driver on entering into LP2 idle-state, but the online status is not touched by the cpuidle. This fixes a storm of warnings once LP2 idling state is enabled on Tegra30. The outer_disable() helper has sanity checks for interrupts and secondary CPUs being disabled and we are pretty confident about the interrupts state during of CPU idling / system suspend. The rail-off status check is added in this patch as equivalent for the "num_online_cpus() > 1". Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Rename some of the newly exposed PM functions

2020-03-13T10:23:08Z

Rename some of the recently exposed PM functions, prefixing them with "tegra_pm_" in order to make the naming of the PM functions consistent. Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Acked-by: Daniel Lezcano Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Propagate error from tegra_idle_lp2_last()

2020-03-12T09:54:05Z

Technically cpu_suspend() may fail and it's never good to lose information about failure. For example things like cpuidle core could correctly sample idling time in the case of failure. Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Acked-by: Daniel Lezcano Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Change tegra_set_cpu_in_lp2() type to void

2020-03-12T09:53:52Z

The Tegra30 CPUIDLE driver has intention to check whether primary CPU was the last CPU that entered LP2 (CC6) idle-state, but that functionality never got utilized because driver never supported the CC6 state for the case where any secondary CPU is online. The new cpuidle driver will properly support CC6 on Tegra30, including the case where secondary CPUs are online, and that knowledge about what CPUs entered into CC6 won't be needed at all because new driver will use different approach by making use of the coupled idle-state and explicitly parking secondary CPUs before entering into CC6. Thus this patch is just a minor cleanup change. Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Acked-by: Daniel Lezcano Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Remove pen-locking from cpuidle-tegra20

2020-03-12T09:53:37Z

Pen-locking is meant to block CPU0 if CPU1 wakes up during of entering into LP2 because of some interrupt firing up, preventing unnecessary LP2 enter that will be resumed immediately. Apparently this case doesn't happen often in practice, I checked how often it takes place and found that after ~20 hours of browsing web, managing email, watching videos and idling (15+ hours) there is only a dozen of early LP2 entering abortions and they all happened while device was idling. Thus let's remove the pen-locking and make LP2 entering uninterruptible, simplifying code quite a lot. This will also become very handy for the upcoming unified cpuidle driver, allowing to have a common LP2 code-path across of different hardware generations. Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Acked-by: Daniel Lezcano Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

ARM: tegra: Add tegra_pm_park_secondary_cpu()

2020-03-12T09:53:18Z

This function resembles tegra_cpu_die() of the hotplug code, but this variant is more suitable to be used for CPU PM because it's made specifically to be used by cpu_suspend(). In short this function puts secondary CPU offline, it will be used by the new CPUIDLE driver. Acked-by: Peter De Schrijver Tested-by: Peter Geis Tested-by: Jasper Korten Tested-by: David Heidelberg Tested-by: Nicolas Chauvet Signed-off-by: Dmitry Osipenko Signed-off-by: Thierry Reding

treewide: Replace GPLv2 boilerplate/reference with SPDX - rule 201

2019-05-30T18:29:52Z

Based on 1 normalized pattern(s): this program is free software you can redistribute it and or modify it under the terms and conditions of the gnu general public license version 2 as published by the free software foundation this program is distributed in the hope it will be useful but without any warranty without even the implied warranty of merchantability or fitness for a particular purpose see the gnu general public license for more details you should have received a copy of the gnu general public license along with this program if not see http www gnu org licenses extracted by the scancode license scanner the SPDX license identifier GPL-2.0-only has been chosen to replace the boilerplate/reference in 228 file(s). Signed-off-by: Thomas Gleixner Reviewed-by: Allison Randal Reviewed-by: Steve Winslow Reviewed-by: Richard Fontana Reviewed-by: Alexios Zavras Cc: linux-spdx@vger.kernel.org Link: https://lkml.kernel.org/r/20190528171438.107155473@linutronix.de Signed-off-by: Greg Kroah-Hartman

firmware: Move Trusted Foundations support

2019-04-17T14:43:03Z

Move the Trusted Foundations support out of arch/arm/firmware and into drivers/firmware where most other firmware support implementations are located. Signed-off-by: Thierry Reding